DSC-T1 (serv.man2) - Sony Digital Camera Service Manual (repair manual). Page 27

6-25

Check that the color reproduction adjustment is done properly.

Mode

STILL ( 

 )

Subject

Color bar chart (Standard picture frame)

Measurement Point

Video terminal of A/V OUT jack of the
cradle

Measuring Instrument

NTSC vectorscope

Specified Value

Each center of all color luminance
points should settle within each color
reproduction frame.

If the data of page: 60, address: 02 is “01”, select page: 60, address:
01, and set data: 00.

Switch setting:
ZOOM ........................................................................... WIDE end
VIDEO OUT (SET UP setting) ............................................ NTSC

1

Check that “1. Data Setting during
Camera System Adjustments” is
performed.

2

Check the picture frame. If
deviated, perform “5. Picture
Frame Setting”.

3

7A

00

Read the data, and memorize the
data.

4

7A

00

00

Set the data.

5

60

01

AB

Set the data.

6

Adjust the GAIN and PHASE of
the vectorscope so that the burst
luminance point is set at the
specified position.

7

Check that each center of all color
luminance points is set in each
color reproduction frame.

1

60

01

00

Set the data.

2

7A

00

Set the data memorized at
“Checking method”.

3

Perform next adjustments.
If finish the camera system
adjustments, release the data
setting.
(See “1. Data Setting during
Camera System Adjustments”.)

Burst position

Fig. 6-1-14.