DSC-RX100M3 (serv.man4) - Sony Digital Camera Service Manual (repair manual). Page 12

DSC-RX100M3_L2

1-9

1.  Turn on the power switch and extend the lens (WIDE end).
2.  Detach the battery.
3.  Apply alcohol to the gap of the Ornamental Plate using tweezers or fine-tipped stick as shown below.
4.  Detach the Ornamental Ring (A).

 

Note:  Do not turn the Ornamental Ring (A) because there is a 

Positioning Boss. Detach the Ornamental Ring A in the 
arrow direction.

Note:  Ornamental Ring (A)は，位置決めのボスがあるため，

左右にひねらず矢印方向に取り外してください。

 

Boss

Solvent

Tweezers

Ornamental Ring (A)

5.  Disengage the four claws and remove the Barrier Block Assy.

 

Barrier Assy

Claws

Claws

1.  Fit the four claws while inserting the barrier lever into the hole and attach the Barrier Block Assy.

 

Hole

Barrier
Lever

Barrier Block Assy

Claws

Claws

 
2.  Peel off the release paper of the Barrier Tape.
3.  Install the Ornamental Ring (A) and press it lightly.

 

Ornamental Ring (A)

Barrier Tapes

Barrier Tapes

Barrier Block Assy

 

 

1.  Peel off the Insulating Sheet (ST3).

 

Insulating Sheet (ST3)

2.  Remove the three screws to detach the Spacer Plates and the CD-847 Flexible Board.

 

CD-847 Flexible Board

Spacer Plate

Seal Rubber

Spacer Plates

3.  Remove the FG Retainer.

 

Claws

FG Retainer

4.  Pull out the FG-PI of front side, and then pull out the FG-PI of rear side.

 

2

 FG-PI (rear side)

Hook

1

 FG-PI (front side)