DSC-P71, DSC-P71M - Sony Digital Camera Service Manual (repair manual). Page 118

Before perform the camera system adjustments, check that the
specified values of “VIDEO SYSTEM ADJUSTMENTS” are sat-
isfied.

For “CAMERA SYSTEM ADJUSTMENTS”, perform in
order of item numbers.

Perform the following data setting before the camera system ad-
justments.
It is not necessary to perform the following data setting everytime
when you perform some items of camera system adjustments con-
tinuously unless the power is turned off. Only when the power is
turned off during this adjustments, perform the data setting again,
then continue the adjustments.

Set up setting:
1) VIDEO OUT of SET UP setting............... NTSC (NTSC mode)

(This adjustment must be performed in NTSC mode, so don't
set the SET UP setting to “PAL”)

Order Page Address Data

Procedure

1

0

01

01

2

A

01

Set the bit value of bit 5 is
“1”, and press PAUSE
button. (Note 1)

3

2

10

Check the bit values of bit3,
bit4 and bit5 are “1”.
(Note 1, 2)

4

A

00

Set the bit value of bit 1 is
“1”, and press PAUSE
button. (Note 1)

5

A

02

Set the bit value of bit 1 is
“1”, and press PAUSE
button. (Note 1)

6

D

21

04

Press PAUSE button.

7

6

C1

Check the data changes to
“02”.

8

6

6C

01

9

Wait for 1 second.

10

E

96

00

Press PAUSE button.

: For the bit values, refer to “5-2. SERVICE MODE”,

“2-3. 2. Bit value discrimination”.

In case of wrong data.
• Select page: 2, address: 00 and set data: 29.
• Select page: 2, address: 01 and set data: 29.
• Select page: 2, address: 0C, set the bit value of bit 1 is

1.

• Select page: 2, address: 04 and set data: 04.

Set the adjusting remote commander to normal LANC,
and the power will be turned, off and on automatically.

Repeat the “Data setting method”, if the power was turned
off and on during the “CAMERA SYSTEM ADJUST-
MENTS”.

Order Page Address Data

Procedure

1

E

96

40

2

6

6C

00

3

D

21

00

Press PAUSE button.

4

A

02

Set the bit value of bit 1 is
“0”, and press PAUSE
button. (Note 1)

5

A

00

Set the bit value of bit 1 is
“0”, and press PAUSE
button. (Note 1)

6

A

01

Set the bit value of bit 5 is
“0”, and press PAUSE
button. (Note 1)

7

0

01

00