Read Sony DSC-H90 (serv.man2) Service Manual online
DSC-H90_L2
1-5
7
Remove the four screws to detach the Rear Mirror Plate Assy and the Flexible Board Retainer.
8
9
Turn the Naruto Gear jig clockwise to set the camera body in the TELE end state.
Note: Turn the Naruto Gear jig to the maximum.
Release the boss of the Flexible Board and pull it out of the hole.
Note: Turn the Naruto Gear jig to the maximum.
Release the boss of the Flexible Board and pull it out of the hole.
Screws
Flexible Board Retainer
Rear Mirror Plate Assy
Flexible board
Hole
Naruto GearLKI
Boss
1-7. CAM TUBE LUBRICATED ASSY REPLACING METHOD
6
Disconnect the Flexible Board from the Connector and release the claw and boss of the Flexible Board from the groove.
Disconnect the flexible board.
Flexible board
Boss
Claw
Groove
Screw
FG Plate Spring
Boss
Claw
Removal
1
2
3
4
5
Remove the screw and remove the Gear Case Assy from the camera body.
Remove the FG Plate Spring while releasing the boss and the claw.
Pull the two sensors out of the Gear Case Assy.
Remove the solder at two points and remove the Gear Case Assy from the Flexible Board.
Remove the Naruto Gear.
Remove the FG Plate Spring while releasing the boss and the claw.
Pull the two sensors out of the Gear Case Assy.
Remove the solder at two points and remove the Gear Case Assy from the Flexible Board.
Remove the Naruto Gear.
Gear Case Assy
Solders
Sensors
Sensors
Flexible board
Flexible board
Lands
Lands
Naruto Gear
Click on the first or last page to see other DSC-H90 (serv.man2) service manuals if exist.