DSC-H90 (serv.man2) - Sony Digital Camera Service Manual (repair manual). Page 11

DSC-H90_L2

1-9

qd

Set the Flexible Board and the Naruto Gear insertion hole as shown in the figure, and then install the Main Unit to the Stationary
Tube while inserting the projection A of the Liner Guide Tube B Lubricated into the perpendicular groove A.

Projection A of the Liner
Guide Tube B Lubricated

Naruto Gear insertion hole

Flexible board

Positioning

Stationary Tube

Perpendicular groove A

Main unit

qf

qg

Turn the Naruto Gear jig clockwise to set the camera body in the TELE end state.
Note: Turn the Naruto Gear jig to the maximum.
Pass the Flexible Board through the hole and clamp it with the boss.

Naruto Gear jig

Flexible board

Hole

Boss

Eyepiece side

Stationary Tube
hole A

Boss A of the
Rear Mirror Plate Assy

qh

qj

qk

While fitting the Stationary Tube hole A with the boss A of the Rear Mirror Plate Assy, install the Main Unit to the Rear Mirror Plate
Assy.
Turn the eyepiece side upward.
Tighten four screws.
Note: Tighten screws in the order shown in the figure.
*Tightening torque = 0.05 

±

 0.01 N.m (0.51 

±

 0.1 kgf cm)

Rear Mirror Plate Assy

Main unit

Screws

1

2

3

4

ql

w;

Turn the Naruto Gear jig counterclockwise to set the camera body in the retracted state.
Note: Turn the Naruto Gear jig to the maximum.
Attach the Naruto Gear.

Naruto Gear jig

Naruto Gear