Read Sony XR-F5100S Service Manual online
4
XR-F5100S
BUS AUDIO IN
BUS CONTROL IN
Cautions
• This unit is designed for negative earth 12 V
DC operation only.
• Do not get the leads under a screw, or caught
in moving parts (e.g. seat railing).
•B efore making connections, turn the car
ignition off to avoid short circuits.
• Connect the yellow and red power input leads
only after all other leads have been connected.
• Run all earth leads to a common earth
point.
• Be sure to insulate any loose unconnected
leads with electrical tape for safety.
Notes on the power supply lead (yellow)
• When connecting this unit in combination with
other stereo components, the connected car
circuit’s rating must be higher than the sum of
each component’s fuse.
circuit’s rating must be higher than the sum of
each component’s fuse.
• When no car circuits are rated high enough,
connect the unit directly to the battery.
Parts Iist (1)
• The numbers in the list are keyed to those in
the instructions.
• The bracket 1 and the protection collar 5 are
attached to the unit before shipping. Before
mounting the unit, use the release keys 6 to
remove the bracket 1 and the protection collar
5
mounting the unit, use the release keys 6 to
remove the bracket 1 and the protection collar
5
from the unit. For details, see “Removing
the protection collar and the bracket (4)” on
the reverse side of the sheet.
the reverse side of the sheet.
• Keep the release keys 6 for future use as
they are also necessary if you remove the
unit from your car.
unit from your car.
Caution
Handle the bracket 1 carefully to avoid injuring
your fingers.
your fingers.
Note
Before installing, make sure that the catches on
both sides of the bracket 1 are bent inwards 2 mm.
If the catches are straight or bent outwards, the unit
will not be installed securely and may spring out.
Before installing, make sure that the catches on
both sides of the bracket 1 are bent inwards 2 mm.
If the catches are straight or bent outwards, the unit
will not be installed securely and may spring out.
Connection example (2)
Notes (2-A)
• Be sure to connect the earth lead before
• Be sure to connect the earth lead before
connecting the amplifier.
• If you connect an optional power amplifier and do
not use the built-in amplifier, the beep sound will
be deactivated.
be deactivated.
Tip (2-B-
)
For connecting two or more CD/MD changers, the
source selector XA-C40 (optional) is necessary.
source selector XA-C40 (optional) is necessary.
2
A
B
AUDIO OUT REAR
BUS AUDIO IN
BUS CONTROL IN
Catch
1
Source selector*
XA-C40
* not supplied
Click on the first or last page to see other XR-F5100S service manuals if exist.