Read Sony XR-C5200R / XR-C5300R / XR-C5300RX Service Manual online
3
SECTION 1
GENERAL
This section is extracted from
instruction manual.
instruction manual.
5
Location of controls
Refer to the pages listed for details.
1
MENU button
9, 11, 12, 13, 15, 17, 19, 22, 24
9, 11, 12, 13, 15, 17, 19, 22, 24
2
Volume control dial
3
SOURCE (TUNER/TAPE/CD/MD)
button 8, 10, 12, 13, 16, 23
button 8, 10, 12, 13, 16, 23
4
PRST/DISC +/– (cursor up/down) buttons
8, 9, 11, 12, 13, 15, 17, 18, 19, 22, 24
During radio reception:
8, 9, 11, 12, 13, 15, 17, 18, 19, 22, 24
During radio reception:
Preset stations select 13
During CD/MD playback:
Disc change 25
5
DSPL/PTY (display mode change/
programme type) button
11, 14, 18, 23, 24
programme type) button
11, 14, 18, 23, 24
6
MODE button 10, 11, 12, 13, 23
During tape playback:
During tape playback:
Playback direction change 10
During radio reception:
BAND select 12
During CD/MD playback:
CD/MD unit select 23
7
Display window
8 Z
(eject) button (located on the front side
of the unit behind the front panel) 10
9
OPEN button 7, 10, 26
q;
D-BASS button 23
qa
SOUND button 21
qs
OFF button
*
2
7, 8, 10
qd
Reset button (located on the front side
of the unit behind the front panel) 7
of the unit behind the front panel) 7
qf
SEEK/AMS –/+ (cursor left/right) buttons
8, 9, 10, 11, 12, 13, 15, 17, 19, 21, 22, 24, 25
8, 9, 10, 11, 12, 13, 15, 17, 19, 21, 22, 24, 25
Seek 13, 15
Automatic Music Sensor 10, 25
Manual search 13, 25
Automatic Music Sensor 10, 25
Manual search 13, 25
qg
ENTER button
9, 11, 12, 13, 15, 17, 18, 19, 22, 24
9, 11, 12, 13, 15, 17, 18, 19, 22, 24
qh
Receptor for the card remote
commander
commander
qj
Number buttons
During radio reception:
During radio reception:
Preset number select 12, 13, 16, 17
During tape playback:
(1)
REP 11
During CD/MD playback:
(1)
REP 25
(2)
SHUF 25
qk
AF button 15, 17
ql
TA button 16, 17
*
2
Warning when installing in a car
without ACC
without ACC
(accessory) position on
the ignition key switch
Be sure to press
Be sure to press
(OFF)
on the unit for
two seconds to turn off the clock display
after turning off the engine.
after turning off the engine.
When you press (OFF) only momentarily,
the clock display does not turn off and this
causes battery wear.
the clock display does not turn off and this
causes battery wear.
D I SC
+
PR
S
T
+
-
D IS C
–
PR
ST
- -
SOURCE
MODE
DSPL
AF
OFF
PTY
ENTER
MENU
SOUND
1
2
3
4
5
6
-SEEK/AMS
REP
SHUF
TA
OPEN
D-BASS
7
A
Attaching the front panel
Place the hole A of the front panel onto the
spindle B on the unit as illustrated, then push
the left side in.
spindle B on the unit as illustrated, then push
the left side in.
Notes
• Be careful not to attach the front panel upside
• Be careful not to attach the front panel upside
down.
•
Do not press the front panel too hard against the
unit when attaching it.
unit when attaching it.
•
Do not press too hard or put excessive pressure
on the display window of the front panel.
on the display window of the front panel.
•
Do not expose the front panel to direct sunlight
or heat sources such as hot air ducts, and do not
leave it in a humid place. Never leave it on the
dashboard of a car parked in direct sunlight or
where there may be a considerable rise in
temperature.
or heat sources such as hot air ducts, and do not
leave it in a humid place. Never leave it on the
dashboard of a car parked in direct sunlight or
where there may be a considerable rise in
temperature.
Caution alarm
If you turn the car ignition off without
removing the front panel, the caution alarm
will beep for a few seconds.
If you connect an optional power amplifier and
do not use the built-in amplifier, the beep
sound will be deactivated.
removing the front panel, the caution alarm
will beep for a few seconds.
If you connect an optional power amplifier and
do not use the built-in amplifier, the beep
sound will be deactivated.
Getting Started
Resetting the unit
Before operating the unit for the first time or
after replacing the car battery, you must reset
the unit.
Remove the front panel and press the reset
button with a pointed object, such as a
ballpoint pen.
after replacing the car battery, you must reset
the unit.
Remove the front panel and press the reset
button with a pointed object, such as a
ballpoint pen.
Note
Pressing the reset button will erase the clock
setting and some memorised functions.
Pressing the reset button will erase the clock
setting and some memorised functions.
Detaching the front panel
You can detach the front panel of this unit to
protect the unit from being stolen.
protect the unit from being stolen.
1
Press
(OFF)
.
2
Press
(OPEN)
, then slide the front panel
to the right side, and pull out from the
left side.
left side.
Notes
• Be sure not to drop the panel when detaching it
• Be sure not to drop the panel when detaching it
from the unit.
•
If you detach the panel while the unit is still
turned on, the power will turn off automatically
to prevent the speakers from being damaged.
turned on, the power will turn off automatically
to prevent the speakers from being damaged.
•
When you carry the front panel with you, use the
supplied front panel case.
supplied front panel case.
Reset button
1
2
x
B
9
2
Press
(ENTER)
.
The clock starts.
After the clock setting is complete, the
display returns to normal playback mode.
display returns to normal playback mode.
Tips
• You can use the convenient CT function to set
• You can use the convenient CT function to set
the clock automatically (page 19).
• When the D.INFO mode is set to ON, the time is
always displayed (page 22).
Setting the clock
The clock uses a 24-hour digital indication.
Example: To set the clock to 10:08
1
Press
(MENU)
, then press either side of
(PRST/DISC)
or
(PRST)
repeatedly until
“CLOCK” appears.
1
Press
(ENTER)
.
The hour indication flashes.
2
Press either side of
(PRST/DISC)
or
(PRST)
to set the hour.
3
Press (+) side of
(SEEK/AMS)
.
The minute indication flashes.
4
Press either side of
(PRST/DISC)
or
(PRST)
to set the minute.
Click on the first or last page to see other XR-C5200R / XR-C5300R / XR-C5300RX service manuals if exist.