Read Sony CDX-GT517EE Service Manual online
6
CDX-GT517EE
BUS AUDIO IN
AUDIO OUT
FRONT
BUS
CONTROL IN
REMOTE
IN
AUDIO OUT REAR
*
3
L
R
AUDIO
OUT
REAR
AUDIO
OUT
FRONT
BUS
AUDIO
IN
1
3
5
7
2
4
6
8
5
7
4
8
6
Negative polarity positions 2, 4, 6, and 8 have striped leads.
1
Purple
+
Speaker, Rear, Right
5
White
+
Speaker, Front, Left
2
–
Speaker, Rear, Right
6
–
Speaker, Front, Left
3
Grey
+
Speaker, Front, Right
7
Green
+
Speaker, Rear, Left
4
–
Speaker, Front, Right
8
–
Speaker, Rear, Left
AMP REM
Max. supply current 0.3 A
Fuse (10 A)
Blue/white striped
3
*
2
Light blue
2
from the car’s power connector
See “Power connection diagram” on the reverse
side for details.
side for details.
*
1
Note for the antenna (aerial) connecting
If your car antenna (aerial) is an ISO (International
Organization for Standardization) type, use the
supplied adaptor 2 to connect it. First connect
the car antenna (aerial) to the supplied adaptor,
then connect it to the antenna (aerial) jack of the
master unit.
Organization for Standardization) type, use the
supplied adaptor 2 to connect it. First connect
the car antenna (aerial) to the supplied adaptor,
then connect it to the antenna (aerial) jack of the
master unit.
*
2
RCA pin cord (not supplied)
*
3
AUDIO OUT can be switched SUB or REAR. For
details, see the Operating Instructions.
details, see the Operating Instructions.
*
4
Insert with the cord upwards
*
5
Supplied with the CD/MD changer
*
1
2
*
2
*
3
*
4
*
5
Positions 1, 2, 3, and 6 do not have pins.
from the car’s speaker
connector
connector
ATT
from car antenna (aerial)
*
2
Source selector
(not supplied)
XA-C40
*
4
*
1
Supplied with XA-C40
XA-C40
4
Yellow
continuous power supply
7
Red
switched power supply
5
Blue
power antenna (aerial) control
8
Black
ground (earth)
6
Orange/White
switched illumination power supply
*
5
Connection diagram
A
To AMP REMOTE IN of an optional power
amplifi er
This connection is only for amplifi ers. Connecting any other
system may damage the unit.
system may damage the unit.
B
To the interface cable of a car telephone
Warning
If you have a power antenna (aerial) without a relay box,
connecting this unit with the supplied power supply lead
3
connecting this unit with the supplied power supply lead
3
may damage the antenna (aerial).
Notes on the control and power supply leads
•
•
The power antenna (aerial) control lead (blue) supplies +12 V
DC when you turn on the tuner, or when you activate the AF
(Alternative Frequency) or TA (Traffi c Announcement) function.
(Alternative Frequency) or TA (Traffi c Announcement) function.
•
When your car has built-in FM/MW/LW antenna (aerial) in the
rear/side glass, connect the power antenna (aerial) control
lead (blue) or the accessory power input lead (red) to the
power terminal of the existing antenna (aerial) booster. For
details, consult your dealer.
lead (blue) or the accessory power input lead (red) to the
power terminal of the existing antenna (aerial) booster. For
details, consult your dealer.
•
A power antenna (aerial) without a relay box cannot be used
with this unit.
Memory hold connection
When the yellow power input lead is connected, power will
always be supplied to the memory circuit even when the ignition
switch is turned off.
When the yellow power input lead is connected, power will
always be supplied to the memory circuit even when the ignition
switch is turned off.
Notes on speaker connection
•
•
Before connecting the speakers, turn the unit off.
•
Use speakers with an impedance of 4 to 8 ohms, and with
adequate power handling capacities to avoid its damage.
•
Do not connect the speaker terminals to the car chassis, or
connect the terminals of the right speakers with those of the
left speaker.
left speaker.
•
Do not connect the ground (earth) lead of this unit to the
negative (–) terminal of the speaker.
•
Do not attempt to connect the speakers in parallel.
•
Connect only passive speakers. Connecting active speakers
(with built-in amplifi ers) to the speaker terminals may damage
the unit.
the unit.
•
To avoid a malfunction, do not use the built-in speaker leads
installed in your car if the unit shares a common negative (–)
lead for the right and left speakers.
lead for the right and left speakers.
•
Do not connect the unit’s speaker leads to each other.
Note on connection
If speaker and amplifi er are not connected correctly, “FAILURE”
appears in the display. In this case, make sure the speaker and
amplifi er are connected correctly.
If speaker and amplifi er are not connected correctly, “FAILURE”
appears in the display. In this case, make sure the speaker and
amplifi er are connected correctly.
A
B
3
Click on the first or last page to see other CDX-GT517EE service manuals if exist.