Read Sony ZS-M30 Service Manual online
15
ZS-M30
4-5-1. Operating the Continuous Playback Mode
1. Entering the continuous playback mode
1 Set the disc in the unit. (Whichever recordable discs or discs for playback only are available)
2 Potate the jog dial and display “CPLAY MODE”.
3 Press the YES/ENTER button to change the display to “CPLAY MID”.
4 When access completes, the display changes to “C1 =
2 Potate the jog dial and display “CPLAY MODE”.
3 Press the YES/ENTER button to change the display to “CPLAY MID”.
4 When access completes, the display changes to “C1 =
AD =
”.
Note: The numbers “ ” displayed show you error rates and ADER.
2. Changing the parts to be played back
1
Press the YES/ENTER button during continuous playback to change the display as below.
CPLAY MID
CPLAY OUT
CPLAY IN
When pressed another time, the parts to be played back can be moved.
2
When access completes, the display changes to “C1 =
AD =
”.
Note: The numbers “ ” displayed show you error rates and ADER.
3. Ending the continuous playback mode
1
Press the NO/CANCEL button. The display will change to “CPLAY MODE”.
2
Press the Z (MD) button and take out the disc.
Note: The playback start addresses for IN, MID, and OUT are as follows.
IN : 40h cluster
MID : 300h cluster
OUT: 700h cluster
MID : 300h cluster
OUT: 700h cluster
4-5-2. Operating the Continuous Recording Mode (Use only when performing self-recording/palyback check)
1. Entering the continuous recording mode
1
Set a recordable disc in the unit.
2
Rotate the jog dial and display “CRDE MODE”.
3
Press the YES/ENTER button to change the display to “CREC MID”.
4
When access completes, the display changes to “CREC (
)” and “REC ” lights up.
Note: The numbers “ ” displayed shows you the recording position addresses.
2. Changing the parts to be recorded
1
When the YES/ENTER button is pressed during continuous recording, the display changes as below.
When pressed another time, the parts to be recorded can be changed. “REC ” goes off.
2
When access completes, the display changes to “CREC (
)” and “REC ” lights up.
Note: The numbers “ ” displayed shows you the recording position addresses.
3. Ending the continuous recording mode
1
Press the NO/CANCEL button. The display changes to “CREC MODE” and “REC ” goes off.
2
Press the Z (MD) button and take out the disc.
Note 1: The recording start addresses for IN, MID, and OUT are as follows.
IN : 40h cluster
MID : 300h cluster
OUT: 700h cluster
MID : 300h cluster
OUT: 700h cluster
Note 2: The NO/CANCEL button can be used to stop recording anytime.
Note 3: Do not perform continuous recording for long periods of time above 5 minutes.
Note 4: During continuous recording, be careful not to apply vibration.
Note 3: Do not perform continuous recording for long periods of time above 5 minutes.
Note 4: During continuous recording, be careful not to apply vibration.
4-5-3. Non-storage memory mode (EEP mode)
This is the mode to read write the contents of the non-volatile storage memory.
This mode is not used for servicing.
If you accidentally enter this mode, exit immediately by pressing the NO/CANCEL button.
This mode is not used for servicing.
If you accidentally enter this mode, exit immediately by pressing the NO/CANCEL button.
CREC MID
CREC OUT
CREC IN
Click on the first or last page to see other ZS-M30 service manuals if exist.