Read Sony STR-DN1060 / STR-DN860 Service Manual online
STR-DN860/DN1060
6
NOTE OF REPLACING THE Q1550, Q1551, Q1600,
Q1601, Q1650, Q1651, Q1700, Q1701, Q1750, Q1751,
Q1800, Q1801, Q1850 AND Q1851 ON THE MAIN
BOARD
Replacement of Q1550, Q1551, Q1600, Q1601, Q1650, Q1651,
Q1700, Q1701, Q1750, Q1751, Q1800, Q1801, Q1850 and
Q1851 on the MAIN board used in this unit requires L type screw
driver.
Q1601, Q1650, Q1651, Q1700, Q1701, Q1750, Q1751,
Q1800, Q1801, Q1850 AND Q1851 ON THE MAIN
BOARD
Replacement of Q1550, Q1551, Q1600, Q1601, Q1650, Q1651,
Q1700, Q1701, Q1750, Q1751, Q1800, Q1801, Q1850 and
Q1851 on the MAIN board used in this unit requires L type screw
driver.
L type screw driver
(e.g Compact 90 degree right
angled ratchet screwdriver (dr-05))
(e.g Compact 90 degree right
angled ratchet screwdriver (dr-05))
NOTE OF REPLACING THE IC1906, IC1911, IC1912,
IC1913, IC1914 AND IC1915 ON THE DCDC BOARD
Replacement of IC1906, IC1911, IC1912, IC1913, IC1914 and
IC1915 on the DCDC Board used in this unit required to unsolder
the grounding wire on the DCDC Board.
IC1913, IC1914 AND IC1915 ON THE DCDC BOARD
Replacement of IC1906, IC1911, IC1912, IC1913, IC1914 and
IC1915 on the DCDC Board used in this unit required to unsolder
the grounding wire on the DCDC Board.
Grounding wire
After replaced the IC1906, IC1911, IC1912, IC1913, IC1914 and
IC1915, have to solder back the grounding wire on the DCDC
Board properly before turn on the set (refer image provided
below).
(Caution: If insuffi cient solder occured for the grounding wire in
DCDC Board, it may caused the set intermittent turn on/off and
will spoil the MB Board)
IC1915, have to solder back the grounding wire on the DCDC
Board properly before turn on the set (refer image provided
below).
(Caution: If insuffi cient solder occured for the grounding wire in
DCDC Board, it may caused the set intermittent turn on/off and
will spoil the MB Board)
NG (Insufficient solder)
OK
Grounding wire area (Conductor View)
CAPACITOR ELECTRICAL DISCHARGE PROCESSING
When checking the board, for the electric shock prevention,
connect the resistors to both ends of respective capacitors (C930
and C931 on the MAIN board) to discharge the capacitors.
When checking the board, for the electric shock prevention,
connect the resistors to both ends of respective capacitors (C930
and C931 on the MAIN board) to discharge the capacitors.
800 /5 W
800 /5 W
C930
C931
– MAIN Board (Conductor Side) –
Click on the first or last page to see other STR-DN1060 / STR-DN860 service manuals if exist.