STR-DA5600ES - Sony Audio Service Manual (repair manual). Page 4

5-85.  Schematic Diagram - F-HDMI Board - ..........................  114
5-86.  Schematic Diagram - PANEL Section - ..........................  115
5-87.  Printed Wiring Board - DISPLAY Board - .....................  116
5-88.  Schematic Diagram - DISPLAY Board (1/3) - ...............  117
5-89.  Schematic Diagram - DISPLAY Board (2/3) - ...............  118
5-90.  Schematic Diagram - DISPLAY Board (3/3) - ...............  119
5-91.  Printed Wiring Boards - DCDC Section - .......................  120
5-92.  Schematic Diagram - DCDC Section - ...........................  121
5-93.  Printed Wiring Boards - POWER SUPPLY Section - ....  122
5-94.  Schematic Diagram - POWER SUPPLY Section - .........  123

6-1. Case 

Section 

....................................................................  

192

6-2.  D-VIDEO Board Section ................................................  193
6-3.  NETWORK Board Section .............................................  194
6-4. Power 

Transformer 

Section 

............................................  

195

6-5.  MAIN Board Section ......................................................  196
6-6. Chassis 

Section 

...............................................................  

197

6-7. Power 

AMP 

Section 

........................................................  

198

6-8.  Heat Sink Section ............................................................  199
6-9.  DISPLAY Board Section ................................................  200
6-10.  Front Panel Section .........................................................  201

  ..............................  202

Accessories are given in the last of the electrical parts list.

UNLEADED  SOLDER
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution:  Some printed circuit boards may not come printed with 

the lead free mark due to their particular size)

Unleaded solder has the following characteristics.
•  Unleaded solder melts at a temperature about 40 °C higher 

than ordinary solder.

 

Ordinary soldering irons can be used but the iron tip has to be 
applied to the solder joint for a slightly longer time.

 

Soldering irons using a temperature regulator should be set to 
about 350 °C.
Caution: The printed pattern (copper foil) may peel away if 

the heated tip is applied for too long, so be careful!

• Strong 

viscosity

 

Unleaded solder is more viscous (sticky, less prone to fl ow) 
than ordinary solder so use caution not to let solder bridges 
occur such as on IC pins, etc.

•  Usable with ordinary solder
 

It is best to use only unleaded solder but unleaded solder may 
also be added to ordinary solder.

US and Canadian models

4-174-078-0

[]

AEP and UK models

4-174-078-1

[]

NOTE  OF  REPLACING  THE  IC3111,  IC3511,  IC3513  
AND  IC3514  ON  THE  D-VIDEO  BOARD
IC3111, IC3511, IC3513 and IC3514 on the D-VIDEO board 
cannot exchange with single. When these parts on the D-VIDEO 
board are damaged, exchange the entire mounted board.

NOTE  OF  REPLACING  THE  IC5002  AND  IC5202  ON  
THE  DSP  BOARD
IC5002 and IC5202 on the DSP board cannot exchange with sin-
gle. When these parts on the DSP board are damaged, exchange the 
entire mounted board.

NOTE  OF  REPLACING  THE  IC8001  AND  IC8013  ON  
THE  NETWORK  BOARD
IC8001 and IC8013 on the NETWORK board cannot exchange 
with single. When these parts on the NETWORK board are dam-
aged, exchange the entire mounted board.