SS-NA5ES - Sony Audio Service Manual (repair manual). Page 9

1 Remove two acoustic absorbents from speaker cabinet.

3 Remove four catchers from four shafts 

3 Remove four catchers from four shafts 

2 tapping screw (BV3.5)

1: When tightening screws, be 

 

 

careful not to put the wire.

2: Check that the screw has not 

 

 

floated or it is not slanting.

3: tightening torTue . “ . 1‡P

2 tapping screw (BV3.5)

1: When tightening screws, be 

 

 

careful not to put the wire.

2: Check that the screw has not 

 

 

floated or it is not slanting.

3: tightening torTue . “ . 1‡P

4: When tightening screws, be careful 

 

 

so that neither a driver nor a screw 

 

 

can touch a capacitor.

4 Pull out the TW board and 

6 TW board block

Stuff the wire (red) into the slit of 
acoustic absorbent.
Note 9: Left side is red when it sees 
 froP the front.

Stuff the wire (black) into the 
slit of acoustic absorbent.
Note 9: Right side is black when 
 

it sees froP the front.

7 WO board block

5 four terminals

Note 5: 7urn the caulking part of a terPinal to the coil side, and connect.
Note 6: Check that the connection Pistake or insertion of a wire are not iPperfect.
Note 7: ,nsert the terPinal straightl\.
Note 8: $fter terPinal insertion, should check acting as lock of the terPinal coPpletel\.