Read Sony SRF-M37 Service Manual online
6
SRF-M37
SECTION 4
DIAGRAMS
1
IC101
tg
XOUT
1.1 Vp-p
13
µ
s
TIME/div : 4
µ
s/DIV
VOLT/div : 500 mV/DIV
2
Q106 collector
1.8 Vp-p
262 ns
TIME/div : 100 ns/DIV
VOLT/div : 500 mV/DIV
VOLT/div : 500 mV/DIV
Note on Schematic Diagram:
• All capacitors are in µF unless otherwise noted. pF: µµF
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
and tantalums.
• All resistors are in
Ω
and
1
/
4
W or less unless otherwise
specified.
•
C
: panel designation.
•
A
: B+ Line.
•
H
: adjustment for repair.
• Power voltage is dc 1.5 V and fed with regulated dc power
supply from battery terminal.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
no mark : FM
<
no mark : FM
<
> : AM
• Voltages are taken with a VOM (Input impedance 10 M
Ω
).
Voltage variations may be noted due to normal produc-
tion tolerances.
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
tion tolerances.
• Circled numbers refer to waveforms.
•
•
Signal path.
F
: FM
f
: AM
• Waveform
Note on Printed Wiring Board:
• Y
: parts extracted from the conductor side.
•
b
: Pattern from the side which enables seeing.
•
: Carbon pattern.
Caution:
Pattern face side: Parts on the pattern face side seen from
(Side B)
Pattern face side: Parts on the pattern face side seen from
(Side B)
the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(Side A)
the parts face are indicated.
• Indication of transistor
Q
C
These are omitted
E
B
Click on the first or last page to see other SRF-M37 service manuals if exist.