Read Sony SRF-M37 Service Manual online
2
SRF-M37
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be
• Notice that the minus side of a tantalum capacitor may be
damaged by heat.
Flexible Circuit Board Repairing
• Keep the temperature of soldering iron around 270˚C
during repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
SECTION 1
GENERAL
This section is extracted
from instruction manual.
from instruction manual.
VOL
POWER
Belt clip / Attache /
Gürtelbefestigung
Gürtelbefestigung
HOLD
CLOCK
TUNE/TIME SET
PRESET TUNING 1-6
BAND
FM SENS
DX
LOCAL
DX
LOCAL
i
jack /
Prise i /
Buchse i
Buchse i
*
1
Setting the Clock
The display will flash “AM 12:00” or “0:00” when the battery is first
inserted.
inserted.
1
Hold down CLOCK for more than 2 seconds.
The beep sounds and the hour flashes in the display.
2
Press TUNE/TIME SET + or – until the correct hour appears in
the display.
the display.
Each press changes the digit(s) by one.
When you keep the button pressed, the digit(s) change rapidly.
When you keep the button pressed, the digit(s) change rapidly.
3
Press CLOCK.
The beep sounds and the minute starts to flash.
Repeat step 2 to set the minute. After setting the
minute, press CLOCK again. The two beeps sound
and the clock starts from 0 seconds.
Repeat step 2 to set the minute. After setting the
minute, press CLOCK again. The two beeps sound
and the clock starts from 0 seconds.
The clock system varies depending on the model you own.
12-hour system: “AM 12:00” = midnight
24-hour system: “0:00” = midnight
12-hour system: “AM 12:00” = midnight
24-hour system: “0:00” = midnight
Click on the first or last page to see other SRF-M37 service manuals if exist.