Read Sony ICF-CD513 Service Manual online
– 3 –
SECTION 1
SERVICING NOTES
CF3
CF1
mark
Mark
Center frequency
red
10.70 MHz
blue
10.67 MHz
orange
10.73 MHz
black
10.64 MHz
white
10.76 MHz
HOW TO CHANGED THE CERAMIC FILTERS
This model is used two ceramic filters of CF1 and CF3.
You must used same type of color marked ceramic filters in order
to meet same specifications.
Therefore, the ceramic filter must changed two pieces together
since it’s supply two pieces in one package as a spare parts.
You must used same type of color marked ceramic filters in order
to meet same specifications.
Therefore, the ceramic filter must changed two pieces together
since it’s supply two pieces in one package as a spare parts.
MODEL IDENTIFICATION – Top View –
MODEL NO. ICF-CD513
US, Canadian models: AC: 120 V 60 Hz 15 W
AEP model: AC: 220 – 230 V 50 Hz 15 W
AEP model: AC: 220 – 230 V 50 Hz 15 W
The laser diode in the optical pick-up block may suffer electro-
static break-down because of the potential difference generated
by the charged electrostatic load, etc. on clothing and the human
body.
During repair, pay attention to electrostatic break-down and also
use the procedure in the printed matter which is included in the
repair parts.
The flexible board is easily damaged and should be handled with
care.
static break-down because of the potential difference generated
by the charged electrostatic load, etc. on clothing and the human
body.
During repair, pay attention to electrostatic break-down and also
use the procedure in the printed matter which is included in the
repair parts.
The flexible board is easily damaged and should be handled with
care.
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused
on the disc reflective surface by the objective lens in the optical
pick-up block. Therefore, when checking the laser diode emis-
sion, observe from more than 30 cm away from the objective lens.
on the disc reflective surface by the objective lens in the optical
pick-up block. Therefore, when checking the laser diode emis-
sion, observe from more than 30 cm away from the objective lens.
NOTES ON HANDLING THE OPTICAL PICK-UP
BLOCK OR BASE UNIT
BLOCK OR BASE UNIT
DISC REMOVAL PROCEDURE (at POWER OFF)
1) Remove the cabinet (upper). (Refer to page 6 “CABINET (UP-
PER)”)
2) Remove the “front assy, cabinet”. (Refer to page 6 “CABI-
NET FRONT ASSY”)
3) Remove the CD mechanism deck. (Refer to page 7 “CD
MECHANISM DECK (KSL-213BGN”)
4) Turn the gear (C) in the direction of the arrow.
5) When the gear (P) reaches the position shown in the figure,
5) When the gear (P) reaches the position shown in the figure,
rotate it towards the arrow (A) position.
6) Pull out the disc table once it comes out a little.
1
gear (C)
2
gear (P)
3
A
Click on the first or last page to see other ICF-CD513 service manuals if exist.