Read Sony HCD-VZ10 Service Manual online
6
This section is extracted from
instruction manual.
instruction manual.
7
Getting Started
Using the remote
You can use the shaded buttons shown below to
operate a Sony TV.
To
Turn the TV on or off
Switch the TV’s
video input
Change the TV
channels
Adjusts the volume
of the TV speaker(s)
Tip
With normal use, the batteries should last for about
six months. When the remote no longer operates the
system, replace both batteries with new ones.
Note
If you do not use the remote for a long period of time,
remove the batteries to avoid possible damage from
battery leakage.
When carrying this system
Do the following to protect the CD mechanism.
Make sure that all discs are removed from the
unit.
1
Press FUNCTION repeatedly until “CD”
appears in the display.
2
Hold down V-GROOVE and press
?/1
so that
“LOCK” appears in the display.
Step 2: Setting the time
You must set the time before using the timer
functions.
The clock is on a 12-hour system.
?/1
(Power)
1
2,3,4,5,6
Press
TV
?/1
.
TV/VIDEO.
TV CH +/–.
TV VOL +/–.
continued
TV
TV VOL +/
TV CH +/
TV/VIDEO
1
Press MODE SELECT when the system
is turned off.
“Clock Set ?” appears.
2
Press PUSH ENTER.
The hour indication flashes.
8
3
Move the multi stick toward
v
or
V
repeatedly to set the hour.
4
Move the multi stick toward
B
.
The minute indication flashes.
5
Move the multi stick toward
v
or
V
repeatedly to set the minute.
6
Press PUSH ENTER.
To cancel the menu operation
Press MODE SELECT.
Tips
•
Refer to the illustration to use the multi stick. Place
your finger on the center of the multi stick and
move in the direction you want (up/down or left/
right shown
v/V
or
b/B
in this manual).
•
If you
’ve made a mistake, start over from step 1.
To change the time
The previous explanation shows you how to set
the time while the power is off. To change the
time while the power is on, do the following:
1
Press MODE SELECT repeatedly to select
“Set
Up Mode
”, then press PUSH ENTER.
2
Move the multi stick toward
b
or
B
repeatedly
to select
“Timer Set Up ?
”, then press PUSH
ENTER.
3
Move the multi stick toward
b
or
B
repeatedly
to select
“Clock Set ?
”, then press PUSH
ENTER.
4
Perform steps 3 through 6 on the left.
Note
The clock settings are canceled when you disconnect
the power cord or if a power failure occurs.
Up (
v
)
Right (
B
)
Left (
b
)
Down (
V
)
Step 2: Setting the time
(continued)
PUSH
ENTER
Click on the first or last page to see other HCD-VZ10 service manuals if exist.