Read Sony HCD-S500HDE / NAS-SC500PK / SS-S500HDE Service Manual online
HCD-S500HDE/SS-S500HDE
5
HOW TO DRAW OUT FORCIBLY THE DISC TRAY
In the event that the disc tray does not come out due to any fail-
ure, three methods are available to draw it out forcibly. Use either
method described below according to the symptom.
In the event that the disc tray does not come out due to any fail-
ure, three methods are available to draw it out forcibly. Use either
method described below according to the symptom.
METHOD 1
If the power did not turn on or if the power is OFF:
1. With the power cord unplugged, remove the panel (side L) /
If the power did not turn on or if the power is OFF:
1. With the power cord unplugged, remove the panel (side L) /
(side R) assembly, panel (top), and panel (front). (See “How to
Remove 2-2, 2-3 (page 8), 2-6 (page 10)”)
Remove 2-2, 2-3 (page 8), 2-6 (page 10)”)
2. As shown in the fi gure, insert a thin rod into the hole at the
lower part of CD block, and push it in the arrow
A direction.
"
Note:
This illustration shows the
disc tray as viewed from
the
bottom.
CD section
thin rod
hole
cushion (CD)
Insert a thin rod into the
hole and push it in the
arrow " direction.
hole and push it in the
arrow " direction.
(Disc tray will come out)
disc tray
Peel the cushion (CD) a
little when it hides the hole.
little when it hides the hole.
METHOD 2
If the CD-ROM drive is turned on but the mother board does not
start:
1. Insert a thin fl at-head screwdriver into a round hole at the bot-
If the CD-ROM drive is turned on but the mother board does not
start:
1. Insert a thin fl at-head screwdriver into a round hole at the bot-
tom of the set.
2. Through a hole at the bottom of CD-ROM drive, short the
points (patterns) on the board of CD-ROM drive.
round hole
round hole
flat-head screwdriver
pattern
Short across patterns with a flat-head screwdriver.
disc tray
flat-head screwdriver
METHOD 3
If the mother board starts but the system software is abnormal:
Plug in the power cord while pressing the [
If the mother board starts but the system software is abnormal:
Plug in the power cord while pressing the [
Z] button.
Note: This method is same as “CD Start Mode” of test modes. Load the
start disc and close the disc tray, and if the start disc is not recog-
nized, start the CD as usual.
nized, start the CD as usual.
;button
power cord
Click on the first or last page to see other HCD-S500HDE / NAS-SC500PK / SS-S500HDE service manuals if exist.