Read Sony HCD-GX8000 / HCD-RG77 Service Manual online
19
HCD-GX8000/RG77
2. Turn the adjustment screw and check output peaks. If the peaks
do not match for L-CH and R-CH, turn the adjustment screw
so that outputs match within 1dB of peak.
so that outputs match within 1dB of peak.
3. Mode: Playback
4. After the adjustments, apply suitable locking compound to the
pats adjusted.
Adjustment Location: Playback Head (Deck A).
Record/Playback/Erase Head (Deck B).
TAPE SPEED ADJUSTMENT
DECK B
Note:
Start the Tape Speed adjustment as below after setting to the test
mode.
In the test mode, the tape speed is high during pressing the
mode.
In the test mode, the tape speed is high during pressing the
[CD SYNC HI-DUB]
button.
Procedure:
1. Press
1. Press
?/1
button to turn the set ON.
2. Press three buttons
x
,
[ENTER]
and
[DISC 3]
simultaneously.
To release from the test mode, press the
?/1
button.
Mode: Playback
1. Insert the WS-48B into the deck B.
2. Press the hH button on the deck B.
3. Press the
2. Press the hH button on the deck B.
3. Press the
[CD SYNC HI-DUB]
button in playback mode.
Then at HIGH speed mode.
4. Adjust RV1001 on the SW board so that frequency counter reads
6,000
±
180 Hz.
5. Press the
[CD SYNC HI-DUB]
button.
Then back to NORMAL speed mode.
6. Adjust RV1002 on the SW board so that frequency counter reads
3,000
±
90 Hz.
Adjustment Location: SW board
Sample Value of Wow and Flutter: 0.3% or less W. RMS (JIS)
(WS-48B)
Screw
position
position
L-CH
peak
peak
within
1dB
1dB
Output
level
level
L-CH
peak
peak
R-CH
peak
peak
within
1dB
1dB
Screw
position
position
R-CH
peak
peak
MAIN
board
CN301
set
board
CN301
set
test tape
P-4-A100
(10 kHz, –10 dB)
P-4-A100
(10 kHz, –10 dB)
pin
3
oscilloscope
L-CH
R-CH
V
H
waveform of oscilloscope
in phase 45
°
90
°
135
°
180
°
good
wrong
pin
2
pin
1
L
R
+
–
–
set
test tape
WS-48B
(3 kHz, 0 dB)
WS-48B
(3 kHz, 0 dB)
MAIN board
CN301 Pin
CN301 Pin
2
(GND)
MAIN board
CN301
Pin
CN301
Pin
1
(L-CH)
Pin
3
(R-CH)
frequency counter
forward
reverse
Click on the first or last page to see other HCD-GX8000 / HCD-RG77 service manuals if exist.