Read Sony DAV-LF1H Service Manual online
3
DAV-LF1H
ASSEMBLING AND CONNECTING THE SYSTEM
Before connecting, attach the stands to the control unit and the speakers.
Tip
We recommend that you spread a cloth on the floor to avoid damaging the floor when assembling.
Assembling the control unit
Attach the stand to the control unit.
Use the parts illustrated below.
Use the parts illustrated below.
Tip
You can install the control unit on a wall using an optional kit (not supplied).
1
Hook the studs of the control unit on the keyslots of the control unit stand, then secure
the control unit with the screw.
the control unit with the screw.
Control unit (1)
Control unit stand (1)
Control unit stand cover
(1)
Screw (black, small)
(1)
Control unit
Control unit stand
,
SYSTEM CONTROL cord
Hook the SYSTEM CONTROL
cord in the clamp on the control
unit stand.
cord in the clamp on the control
unit stand.
Screw (black, small)
2
Attach the control unit stand cover to the control unit stand.
Snap the control unit stand cover onto the control unit stand.
Control unit stand cover
Control unit stand
,
Draw the SYSTEM CONTROL cord
through the opening of the control unit
stand cover.
through the opening of the control unit
stand cover.
Assembling the speakers
Attach the stands and connect the speaker cords to the center speaker, front speakers, and surround
speakers.
speakers.
About connecting speaker cord
The connector and color tube of the speaker cords are the same color as the label of the speaker to be
connected.
connected.
To avoid short-circuiting the speakers
Short-circuiting of the speakers may damage the system. To prevent this, be sure to follow these
precautions when connecting the speakers. Make sure the bare wire of each speaker cord does not touch
another speaker terminal or the bare wire of another speaker cord, such as shown below.
precautions when connecting the speakers. Make sure the bare wire of each speaker cord does not touch
another speaker terminal or the bare wire of another speaker cord, such as shown below.
Note
Be sure to match the speaker cord to the appropriate terminal on the components: 3 to 3, and # to #. If the cords
are reversed, the sound will lack bass and may be distorted.
To assemble the center speaker
Use the parts illustrated below.
Tip
You can install the center speaker on a wall using an optional kit (not supplied).
Center speaker (1)
Adjuster (1)
Center speaker
base (1)
Speaker cord
(green) (1)
Screws
(silver, large) (2)
Label on the rear of the
speaker: Green
Color tube
(–)
(+)
Gray
Black
Do not catch the
speaker cord insulation
in the SPEAKER jack.
speaker cord insulation
in the SPEAKER jack.
Stripped speaker cord is
touching another speaker
terminal.
touching another speaker
terminal.
Stripped cords are touching each
other due to excessive removal of
insulation.
other due to excessive removal of
insulation.
1
Secure the adjuster and center speaker base with the screws.
To adjust the angle of the center speaker
You can set the angle by adjusting the position of the screws.
Center speaker
Screws (silver, large) (2)
* Adjust the length of
the speaker cord
before securing.
before securing.
m
Center speaker base
Adjuster
Speaker cord
*
(green)
Draw out the speaker cord through the slit on the
center speaker base.
center speaker base.
Insert the projections of
the adjuster into the
holes of the center
speaker.
the adjuster into the
holes of the center
speaker.
Gray
Black
Screws
12
°
ASSEMBLING THE SYSTEM
This section is extracted
from instruction manual.
from instruction manual.
Click on the first or last page to see other DAV-LF1H service manuals if exist.