Read Sony DAR-X1R / HCD-X1R Service Manual online
HCD-X1R
18
3-11. DVD DRIVE (DRW-V35A)
2
connector
(CN2)
(CN2)
harness
(POWER-DVDRW)
(POWER-DVDRW)
hard disk
clamp (L35)
clamp (L35)
harness
(SATA POWER001)
(SATA POWER001)
Note: Refer to SERVICING NOTES
“ NOTE ON POWER BLOCK”
(page 7).
(page 7).
Note: Refer to SERVICING NOTES
“ NOTE WHEN INSTALLING THE TOP PANEL
(DISCHAGING METHOD)”
(page 9).
(DISCHAGING METHOD)”
(page 9).
Note: When harness (POWER-DVDRW) and
flexible flat cable (RD-RW01), set it as shown
in the figure.
in the figure.
harness (POWER-DVDRW)
flexible flat cable
(RD-RW01)
(RD-RW01)
1 to 5 mm
Note: Bend press the clamp (L35) to down side
(chassis assy) to arrange the
harness (POWER-DVDRW)
from DVD drive (DRW-V35A) and
harness (SATA POWER001)
from hard dick as shown as figure.
harness (POWER-DVDRW)
from DVD drive (DRW-V35A) and
harness (SATA POWER001)
from hard dick as shown as figure.
1
flexible flat cable
(RD-RW01) (CN101)
(RD-RW01) (CN101)
9
two tapes (clamp)
qd
two tapes (clamp)
qa
Peel off the cushion (yokan).
qf
flexible flat cable
(RD-RW01)
(RD-RW01)
qs
tape (side)
8
clamp (L35)
qg
DVD drive
(DRW-V35A)
(DRW-V35A)
DVD drive
DRW-V35A
DRW-V35A
DVD drive
(DRW-V35A)
(DRW-V35A)
q;
harness (POWER-DVDRW)
6
Remove the DVD drive (DRW-V35A)
section in the derection of the arrow.
section in the derection of the arrow.
4
clamp (L35)
HARNESS (POWER-DVDRW/
SATA POWER001) SETTING
SATA POWER001) SETTING
HARNESS (POWER-DVDRW) AND
FLEXIBLE FLAT CABLE (RD-RW01)
SETTING
FLEXIBLE FLAT CABLE (RD-RW01)
SETTING
two tapes (clamp)
two tapes (clamp)
3
screw
(BVTP3
(BVTP3
×
10)
7
screw
(B3
(B3
×
5)
5
three screws
(BVTP3
(BVTP3
×
10)
Click on the first or last page to see other DAR-X1R / HCD-X1R service manuals if exist.