Read Sony CMT-G2BNIP / CMT-G2NIP / HCD-G2BNIP / HCD-G2NIP Service Manual online
HCD-G2BNiP/G2NiP
13
2-5. PANEL (FRONT) BLOCK
– Rear side view –
1
Lift up two
coating
clips.
4
Lift up the coating clip.
5
Turn over the flexible
flat cable (15 core).
2
connector (CN805)
3
connector
(CN601)
6
flexible flat cable (19 core)
(CN404)
7
two screws
(BV3)
0
claw
0
claw
9
two screws
(BV/ring)
qa
panel (front) block
8
screw
(BVTP3
u 8)
8
screw
(BVTP3
u 8)
Insert is straight to the interior
Insert is incline
flexible flat
cable
cable
flexible flat
cable
cable
connector
connector
OK
NG
Note 4: When you install the flexible flat cable, please install them
correctly.
correctly.
There is a possibility that this machine damages when not
correctly installing it.
Note 1: There is a possibility of damaged of the panel (CD tray) when the
panel (front) block is removed without removing the panel (CD tray).
Remove panel (CD tray) earlier than removing the panel (front) block.
Note 5: Refer to “WIRE SETTING” on page 9 for the setting of those other than this.
– Front panel inner view –
front side
sleeve ferrite clamp
HP board
USB board
JOG2 board
tape
The wire must be on the
sleeve ferrite clamp.
sleeve ferrite clamp.
The sleeve ferrite clamp must
come under the USB board.
come under the USB board.
:ire settinJ
holder (CD)
CD mechanism deck
cover (CD top)
Note 2: When you install the panel (front) block,
put two sleeve ferrite clamps within this
dotted line range.
Note 3: Confirm the BD94DC board has not dropped.
Click on the first or last page to see other CMT-G2BNIP / CMT-G2NIP / HCD-G2BNIP / HCD-G2NIP service manuals if exist.