Read Sony CMT-G2BNIP / CMT-G2NIP / HCD-G2BNIP / HCD-G2NIP Service Manual online
HCD-G2BNiP/G2NiP
14
2-6. PANEL (REAR) BLOCK
Note 1: Refer to “WIRE SETTING” on page 9 for wire setting.
2
coating clip
1
two screws
(BVTP2.6)
– Rear side view –
(G2BNiP)
Insert is straight to the interior
Insert is incline
flexible flat
cable
cable
flexible flat
cable
cable
connector
connector
OK
NG
Note 2: When you install the flexible flat cable, please install them
correctly. There is a possibility that this machine damages
when not correctly installing it.
3
holder (BREDGECO)
5
2.4 GHz antenna
connector
6
connector
(CN5004)
7
connector
(CN701)
8
connector
(CN4404)
4
Lift up the lead pin.
9
connector
(CN4405)
0
flexible flat cable (9 core) (CN407)
Note
4: Both the flexible flat cable (9 core) can be connected with
the CN406 or CN407 on MAIN board.
When you connect the flexible flat cable (9 core) with the
CN407 on MAIN board so as not to connect it by mistake.
qa
flexible flat cable (8 core) (CN408)
CN406
qs
two screws
(BV/ring)
qf
screw
(BV3)
qg
coating clip
coating clip
AC inlet
qh
panel (rear) block
qs
three screws
(BV/ring)
qd
– Rear side view –
Clamp tilter (ferrite core) setting
clamp tilter (ferrite core)
55 mm
rear side
wireless LAN module
(MOD1)
(MOD1)
OK
NG
NG
Note 3: There are two terminals for antenna wire in a module.
When connecting the antenna wire, connect with the
right
terminal.
Click on the first or last page to see other CMT-G2BNIP / CMT-G2NIP / HCD-G2BNIP / HCD-G2NIP service manuals if exist.