Read Sony CMT-C7NT / HCD-C7NT Service Manual online
18
HCD-C7NT
3-13. Jack Board, HP Board, Rear Cover
3-12. Spindle Motor Assy (M904)
4
two screws
(+P 1.7 x 2.2)
5
turn table
1
clip arm spring (L)
2
clip arm spring
3
open to direction of the arrow
A
A
6
washer
7
spindle motor
8
spindle motor assy
(M904)
3
three screws
(+BV 3 x 8)
2
four screws
(+BV 3 x 12)
1
screw
(+BVTT 3 x 5)
qa
two screws
(+B 4 x 16)
qf
rear cover
6
JACK board
4
two screws
(+BV 3 x 8)
qs
two nuts
(N4)
8
connector
(CN109)
9
connector
(CN110)
5
connector
(CN107)
7
screw
(+PTPWH 3 x 8)
0
HP board
qd
D.C.fan
(M901)
Note for re-installation-1
When installing the rear cover,
be careful that the three harnesses
coming from
“
be careful that the three harnesses
coming from
“
5
Connector (CN107)”,
“
8
Connector (CN109)”,
“
9
Connector (CN110)”,
and the harness coming from the
DC fan (M901) must not contact the
heat sink (IC902) and the diode
(D981) and the heat sink (IC904).
DC fan (M901) must not contact the
heat sink (IC902) and the diode
(D981) and the heat sink (IC904).
heat sink (IC902)
POWER board
diode (D981)
Note for re-installation-2
When installing the rear cover, be careful that the three
harnesses coming from
“
harnesses coming from
“
5
Connector (CN107)”,
“
8
Connector (CN109)”,
“
9
Connector (CN110)”,
and the harness coming from the D.C. fan (M901) must not
be pinched by the rear cover, the UCOM board, power
transformer (T900) and tuner pack.
be pinched by the rear cover, the UCOM board, power
transformer (T900) and tuner pack.
Click on the first or last page to see other CMT-C7NT / HCD-C7NT service manuals if exist.