Read Sony CDP-XB820 Service Manual online
– 16 –
6-2.
NOTE FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS
Note on Schematic Diagram:
• All capacitors are in µF unless otherwise noted. pF: µµF
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
and tantalums.
• All resistors are in
Ω
and
1
/
4
W or less unless otherwise
specified.
•
¢
: internal component.
•
5
: fusible resistor.
•
C
: panel designation.
•
U
: B+ Line.
•
V
: B– Line.
• Voltages and waveforms are dc with respect to ground in
playback mode.
no mark : PLAY
no mark : PLAY
• Voltages are taken with a VOM (Input impedance 10 M
Ω
).
Voltage variations may be noted due to normal produc-
tion tolerances.
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
• Signal path.
J
: CD
c
: digital out
Note: The components identified by mark
!
or dotted line
with mark
!
are critical for safety.
Replace only with part number specified.
Note on Printed Wiring Boards:
• X
: parts extracted from the component side.
•
®
: Through hole.
• b
: Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side:
Pattern face side:
Parts on the pattern face side seen from
(Side B)
the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(Side A)
the parts face are indicated.
C
B
These are omitted.
E
Q
• Indication of transistor.
B
These are omitted.
C
E
Q
Click on the first or last page to see other CDP-XB820 service manuals if exist.