Read Sharp VC-S2000 (serv.man19) User Guide / Operation Manual online
30
If problems persist contact the SHARP Helpline on tel: 08705-274277 (office hours)
or www.sharp.co.uk/support
ADVANCED OPERATION
REMOTE CONTROL OPERATION OF TV
In addition to operating the VCR the remote control will also operate basic functions on TVs,
including brands other than SHARP.
including brands other than SHARP.
SETTING UP THE VCR REMOTE
CONTROL TO OPERATE THE TV
CONTROL TO OPERATE THE TV
1.
Switch on the TV. Open the door on the
remote control and point the unit at the TV.
remote control and point the unit at the TV.
2.
Hold down
TV BRAND SET
on the VCR
remote control and the appropriate
button for the TV from the list shown, for 2
seconds. For example for a SHARP TV, press
button for the TV from the list shown, for 2
seconds. For example for a SHARP TV, press
TV BRAND SET
and
1
.
3.
The TV will enter standby mode to confirm
the correct code has been entered.
the correct code has been entered.
4.
To turn the TV on from standby mode hold
TV BRAND SET
and
1
(Sharp TV) for
about 2 seconds.
CONTROLLING THE TV WITH THE VCR REMOTE CONTROL
•
TV OPERATE
Switches the TV to and from Standby Mode.
•
TV INPUT SELECT
Determines which input to the TV is to be displayed on the
screen.
screen.
•
TV CH
/
Changes the TV channels.
•
TV VOL
/
Increases or decreases the volume.
•
Certain models of TV do not use standard codes for their brand. In this case hold down
TV BRAND SET
, then press each of the buttons in the list until the TV enters stand-by
mode (You will need to reset when remote control batteries are replaced).
•
SHARP cannot guarantee the VCR remote control will operate your TV.
TV BRAND
BUTTON
TV BRAND
BUTTON
SHARP
1
TOSHIBA
9
PHILIPS
2
PANASONIC
0 or
THOMSON
3 or 4
HITACHI
INPUT SELECT
GRUNDIG
5
SANYO
MODE OSD
FERGUSON
6
JVC
DISPLAY
ITT NOKIA
7
MITSUBISHI
AUDIO OUT
SONY
8
+
TINS-3894 ENGLISH.book Page 30 Wednesday, September 6, 2000 11:53 AM
Click on the first or last page to see other VC-S2000 (serv.man19) service manuals if exist.