Read Sharp VC-MH742HM (serv.man32) User Guide / Operation Manual online
GB-10
INSTALLING YOUR VCR
AUTO INSTALLATION
NOTES:
All the programmes should now be correctly tuned in and the clock
set.
set.
If you replace your satellite receiver, you will need to follow the complete auto-
installation procedure to tune your VCR to the satellite receiver. This is because your
new satellite receiver will not over-write the previous satellite channels in your VCR.
installation procedure to tune your VCR to the satellite receiver. This is because your
new satellite receiver will not over-write the previous satellite channels in your VCR.
If problems persist contact the SHARP Customer Helpline on tel: 0990-274277
• If your satellite receiver has not changed to preset channel 12 enter the next code
number on the list. Continue until the receiver shows preset channel 12, then continue
from point 9.
from point 9.
• If your satellite receiver is not listed at the end of this manual or after entering all the
numbers listed for your receiver, the satellite receiver preset channel has still not changed
to 12, enter
to 12, enter
0 0 1
, and look to see if the satellite receiver has changed to preset channel
12. If it has, continue from point 9. If not, press
to select
0 0 2
and re-check. Continue
until your receiver changes to preset 12, then continue from point 9.
• If there is still no response from your satellite receiver, try adjusting its position to improve
the Infra Red VCR to satellite receiver reception.
• Auto-installation will stop when the satellite receiver reaches preset channel 999, or when
all the 84 VCR preset channels have been used.
• The VCR will place all found terrestrial channels starting at preset 1, then all satellite
channels from the first available preset channel after the terrestrial channels.
If you connect a satellite receiver to the VCR for the first time, after auto-installation, see
SATELLITE RECEIVER / CABLE BOX INSTALLATION
.
On completion the MOVE menu will appear
showing the preset channel order.
Press
showing the preset channel order.
Press
MENU
to exit if you are happy with the
channel order, if not and you wish to change
the order refer to
the order refer to
MANUALLY SORTING
CHANNELS
.
If the clock is not automatically set, the clock
screen will appear, refer to
screen will appear, refer to
MANUALLY
SETTING THE CLOCK
for help on setting
the time and date.
To check the clock has been set correctly
press the
press the
DISPLAY
button until the time
appears on the VCR display.
MENU
SET
CLEAR
SV/V+
10
10.
742.book Page 10 Tuesday, August 10, 1999 1:06 PM
Click on the first or last page to see other VC-MH742HM (serv.man32) service manuals if exist.