Read Sharp VC-MH742HM (serv.man32) User Guide / Operation Manual online
GB-9
INSTALLING YOUR VCR
AUTO INSTALLATION
If problems persist contact the SHARP Customer Helpline on tel: 0990-274277
MENU
SET
CLEAR
SV/V+
7
MENU
SET
CLEAR
SV/V+
8
9
7.
Press [
/
], to select INPUT. L2 will be
highlighted.
If the VCR is not connected to the satellite
receiver as shown in
receiver as shown in
CONNECTING THE
CABLES
.
i.
Your satellite receiver should be connected to
the Antenna (RF in on the back of the VCR)
select RF IN using [
the Antenna (RF in on the back of the VCR)
select RF IN using [
/
] You will need to tune
the VCR into the Digibox.
Refer to
CONNECTING A SATELLITE
RECEIVER/CABLE BOX TO YOUR VCR
for
connection diagram.
ii.
Press [
/
] to select CHANNEL.
Press [
]. The current channel will be
displayed as a background to the on-screen
display. If this is not a satellite channel press [
display. If this is not a satellite channel press [
]
again. Continue until you see a satellite
channel.
channel.
8.
Press [
/
] to select SAT NO. Turn to the
table at the end of this manual. Look for the
make of your satellite receiver and use the
make of your satellite receiver and use the
NUMBER BUTTONS
to enter the first
code number listed. For example number 8
should be entered 0 0 8. Your satellite should
now change to preset channel 12.
should be entered 0 0 8. Your satellite should
now change to preset channel 12.
9.
If your satellite receiver has changed to preset
channel 12, press
channel 12, press
SET
to confirm and the
VCR will automatically install both satellite and
terrestrial channels. (This may take a few
minutes).
terrestrial channels. (This may take a few
minutes).
The VCR will attempt to copy the TV preset list
(NexTView, Smart Link, Easy Link and
Megalogic compatible TV’s only). During the
copying process the display will show the TV
presets that are being copied. If the VCR is
unable to copy the TV preset list the terrestrial
and satellite channels will be automatically
installed. (Auto install may take a few minutes.)
(NexTView, Smart Link, Easy Link and
Megalogic compatible TV’s only). During the
copying process the display will show the TV
presets that are being copied. If the VCR is
unable to copy the TV preset list the terrestrial
and satellite channels will be automatically
installed. (Auto install may take a few minutes.)
742.book Page 9 Tuesday, August 10, 1999 1:06 PM
Click on the first or last page to see other VC-MH742HM (serv.man32) service manuals if exist.