Read Sharp VC-MH731HM (serv.man10) User Guide / Operation Manual online
7
INSTALLING YOUR VCR
AUTO INSTALLATION
5.
SAT RECEIVER
SAT CONTROL
ON
OFF
INPUT
RFIN
L2
CHANNEL
CH21
SAT NO.
001
PLEASE CONNECT
. . .
SAT
L2
VCR
_ _ _ _ _ _ _ _ _
➞
:
SELECT
: CHANGE
SET: ENTER MENU: EXIT
VCR RESET
1.Press STOP to switch on the VCR.
2.Press and hold MENU and CHANNEL
2.Press and hold MENU and CHANNEL
buttons together on the front of the VCR
for 10 seconds.
3.The AUTO INSTALLATION screen should now
be showing on your TV. Press SET to confirm.
4.Ensure your AERIAL/SCART cable is
connected to your VCR and then press SET
to confirm.
to confirm.
5.SAT CONTROL will be highlighted.
●
●
If you
do have a satellite receiver connected to
the VCR continue from point 6.
●
If you
do not have a satellite receiver
connected to the VCR leave SAT CONTROL
set to OFF and press SET.
set to OFF and press SET.
▲
▼
▲ ▼
The VCR will attempt to copy the TV preset list (NexTView, Smart Link, Easy Link and
Megalogic compatible TV’s only). During the copying process the display will show the TV
presets that are being copied. If the VCR is unable to copy the TV preset list the terrestrial
channels will be automatically installed. (Auto install may take a few minutes.) On
completion the MOVE menu will appear showing the preset channel order. Press MENU to
exit. If the clock is not automatically set, the clock screen will appear, refer to Manually
Setting The Clock. To check the clock has been set correctly, press DISPLAY until the time
appears on the display. If you wish to customise the channel order refer to Manually Sorting
Channels.
Megalogic compatible TV’s only). During the copying process the display will show the TV
presets that are being copied. If the VCR is unable to copy the TV preset list the terrestrial
channels will be automatically installed. (Auto install may take a few minutes.) On
completion the MOVE menu will appear showing the preset channel order. Press MENU to
exit. If the clock is not automatically set, the clock screen will appear, refer to Manually
Setting The Clock. To check the clock has been set correctly, press DISPLAY until the time
appears on the display. If you wish to customise the channel order refer to Manually Sorting
Channels.
Points 6-11. (Satellite/Cable Box Control only)
6.Select Channel 1 on your satellite receiver.
7.Press [
7.Press [
] to set SAT CONTROL to ON.
8.Press [
] to select INPUT. L2 will be highlighted. If the VCR is not connected to the
satellite receiver as shown previously.
(i)
Then if your satellite receiver is connected to the Antenna (RF in on the back of the
VCR) select RF IN using [
VCR) select RF IN using [
]. You will need to tune the VCR into the Satellite
receiver.
(ii)
Press [
] to select CHANNEL.
(iii) Press [
]. The current channel will be displayed as a background to the on-screen
display. If this is not a satellite channel press [
]again. Continue until you see a
satellite channel.
/
/
/
/
All the programmes should now be correctly tuned in and the clock set.
vc-m331/mh731hm 3/2/99 1:34 pm Page 11
Click on the first or last page to see other VC-MH731HM (serv.man10) service manuals if exist.