Read Sharp LC-45GD1E (serv.man46) User Guide / Operation Manual online
49
Basic adjustment settings (Analogue/Digital)
No signal off
When set to “Enable”, the power will automatically shut
down if no signal inputs for 15 minutes.
down if no signal inputs for 15 minutes.
Press a/b to select “No Signal Off”, and
then press OK.
then press OK.
Press c/d to select “Enable”, and then
press OK.
press OK.
3
4
• Five minutes before the power shuts down,
remaining time displays every minute.
NOTE
• “Disable” is factory preset value.
• When a TV programme finishes, and the AVC System
• When a TV programme finishes, and the AVC System
receives signal input, this function may not operate.
Press c/d to select “Power Control”.
2
Press MENU and the MENU screen displays.
1
No operation off
When set to “Enable”, the power will automatically shut
down if there is no operation for 3 hours.
down if there is no operation for 3 hours.
Press a/b to select “No Operation Off”, and
then press OK.
then press OK.
Press c/d to select “Enable”, and then
press OK.
press OK.
3
4
•
Five minutes before the power shuts down,
remaining time displays every minute.
remaining time displays every minute.
NOTE
• “Disable” is factory preset value.
Press c/d to select “Power Control”.
2
Press MENU and the MENU screen displays.
1
Power control
Power control setting allows you to save energy.
Power control for AV source
Power control for PC source
Power control setting allows you to save energy.
Power management
When set, the power will automatically shut down.
Press a/b to select “Power Management”,
and then press OK.
and then press OK.
Press a/b to select “Mode1” or “Mode2”,
and then press OK.
and then press OK.
3
4
Description
• No power management
• Factory preset value.
• Factory preset value.
• If no signal inputs for 8 minutes, the power
shuts down.
• Even if you start using the PC and the signal
inputs again, the System stays off.
• The System turns on again by pressing
POWER (B) on the AVC System or B on
the remote control unit. (See page 20.)
the remote control unit. (See page 20.)
• If no signal inputs for 8 seconds, the power
shuts down.
• When you start using the PC and the signal
inputs again, the System turns on.
• The System turns on again by pressing
POWER (B) on the AVC System or B on
the remote control unit. (See page 20.)
the remote control unit. (See page 20.)
Selected item
Off
Mode1
Mode2
Press c/d to select “Power Control”.
2
Press MENU and the MENU screen displays.
1
LC-45GD1E(E)-g
04.9.27, 10:16 AM
49
