LC-37GE1E (serv.man6). Adjustment Proceedures - Sharp TV Service Manual (repair manual). Page 6

LC-37GE1E

6 – 6

1. Press the “POWER” key on the set of running TV set to force off the power.

2. While holding down the “VOL(-)” and “MENU” keys on the set at once, press the “POWER” key on the set to turn on the power. The letter 

appears on the screen.

3. Next, hold down the “VOL(-)” and “P(

)” keys on the set at once. Multiple lines of orange  characters appearing on the screen indicate that the

set is  now in the  adjustment Process mode. If you fail to enter the adjustment process mode (the display is the same as normal startup),  retry the
procedure.

4. To exit the adjustment process mode after the adjustment is done, unplug the AC power cord to force off  the power. (When the power is turned off

with the remote controller, once unplug the AC power cord and  plug it in again. In this case, wait 10 seconds or so before plugging.)

5. To remove "K" mode, just repeat steps 1 and 2.  This time the letter "K" disappears from screen.

CAUTION: Use due care in handling the information described here lest the users should  know how to enter the adjustment process mode. If the set-

tings are tampered with in this mode, unrecoverable system damage may result.

1. Key operation

*Input mode is switched automatically when relevant adjustment is started so far as the necessary input signal is available.

2. Description of display

P(

/

)

—————

Changing a selected line setting (+10/-10)

VOL ( + / - )

VOL ( + / - )

Turning a page (PREVIOUS/NEXT)

Cursor (UP/DOWN)

—————

Moving an item (line) by one (UP/DOWN)

Cursor (LEFT/RIGHT)

—————

Turning a page (PREVIOUS/NEXT)
Changing a selected item setting (+1/-1)

—————

MENU

Direct control on TV set
(Input/Wide Mode/Bright/Contrast)(Not Operative)

INPUT SOURCE
on remote controller

—————

Input source switching (toggle switching)
(TV

→EXT1→EXT2→EXT3→EXT4)(Not Operative)

RETURN

—————

Returning to a present page

OK

—————

Executing a function

K

(1) Current page title

(3) Current page item

[INIT]

[PAL+TUNERMAIN] [COMP] [SCART RGB] [TUNER]

37GE1E ver1.XX XXXX.XX.XX

Dev Version

Center Acutime

Backlight Acutime

XX

Temp Sensor

[2]

[3]

[4]

[5]

Error Standby Cause

[1]

XX

XX

XX

Normal Standby Cause

XX

Main Version

XX

Dev Loader Version

XX

(2) Parameters