Read Sharp LC-37GD1E (serv.man12) Service Manual online
36
6
5
4
3
2
1
A
B
C
D
E
F
G
H
LC-32GD1E
LC-37GD1E
LC-37GD1E
DESCRIPTION OF SCHEMATIC DIAGRAM
CAUTION:
This circuit diagram is original one, therefore there may be a
slight difference from yours.
slight difference from yours.
IMPORTANT SAFETY NOTICE:
PARTS MARKED WITH “
å
”
( )ARE IMPORTANT
FOR MAINTAINING THE SAFETY OF THE SET. BE SURE
TO REPLACE THESE PARTS WITH SPECIFIED ONES FOR
MAINTAINING THE SAFETY AND PERFORMANCE OF
THE SET.
TO REPLACE THESE PARTS WITH SPECIFIED ONES FOR
MAINTAINING THE SAFETY AND PERFORMANCE OF
THE SET.
VOLTAGE MEASUREMENT CONDITION:
1. The voltage of each part is the value on operation of
the monitor only. It is measured using a 20 k
Ω
/V tester.
INDICATION OF RESISTOR & CAPACITOR:
RESISTOR
1. The unit of resistance “
1. The unit of resistance “
Ω
” is omitted.
(K=k
Ω
=1000
Ω
, M=M
Ω
).
2. All resistors are ± 5%, unless otherwise noted.
(J= ± 5%, F= ± 1%, D= ± 0.5%)
3. All resistors are Carbon type, unless otherwise noted.
C
: Solid
W
: Cement
S
: Oxide Film
T
: Special
N
: Metal Coating
CAPACITOR
1. All capacitors are mF, unless otherwise noted.
1. All capacitors are mF, unless otherwise noted.
(P=pF=mmF).
2. All capacitors are Ceramic type, unless otherwise
noted.
(ML) : Mylar
(ML) : Mylar
(TA) : Tantalum
(PF) : Polypro Film
(ST) : Styrol
Display
