LC-32WD1E - Sharp TV Service Manual (repair manual). Page 14

5 - 3

LC-32WD1E/S/RU and LC-32WT1E

1.

Disconnect the TV from AC power. Wait 10 seconds. 

Do NOT go to standby first. Just unplug the power cord. 

2.

Connect the TV with the set up as described in “Analogue Upgrade Hardware Setup” on page 5-2. 

3.

Connect the TV to AC power.

4.

Press 

 to turn the TV on. (The Standby/On LED on the front of the TV is GREEN.)

5.

Open ServUpdtTelos_v1_8.exe. 

6.

Connect the USB cable (connected to the Service PCB and Telos device assembly) to the controlling PC. 

7.

In ServUpdtTelos_v1_8.exe, be sure that the checkbox by Enter ISP is highlighted automatically. 

8.

Select the image file(s) you want to upgrade. 

a.

For each image file that you want to upgrade, press Select to open a browse window. 

b.

Browse to the location of the new image files and select the file. 

If Enter ISP is not automatically checked, try to select the Enter ISP button. If this does 
not highlight the checkbox, close the application and re-check your setup as described in 
“Analogue Upgrade Hardware Setup”, power the TV on and off, and then start over at 
step1.

• The image files must be on the hard drive of the controlling PC. They cannot be on a 

network connection. 

• The image file names may vary. Use the release notes to identify the correct image 

file.