Read Sharp LC-32SH130K (serv.man11) Service Manual online
73
LC-32SH130E
LC-32SH130K
LC-32SH340E
TV (TV channel number 1)
Other enabled external sources via service menu or config tool (EXT1, HDMI2, PC, FAV, SVHS etc.)
Other enabled external sources via service menu or config tool (EXT1, HDMI2, PC, FAV, SVHS etc.)
2.14.8
Startup Channel
Specifies the starting TV channel‟s ID which will be tuned when startup position is TV
2.14.9
Volume Limit
Sets the maximum value the volume can have. “Volume Limit” can take values between 0-63.
2.14.10
Fixed Volume Enable
Enables (Fixed Volume Enable = On) or prohibits (Fixed Volume Enable = Off) the use of fixed volume value
which is set by menu item “Fixed Volume Value”. If Fixed Volume Enable is ON, volume cannot be set to a
value other than the Fixed Volume Value.
which is set by menu item “Fixed Volume Value”. If Fixed Volume Enable is ON, volume cannot be set to a
value other than the Fixed Volume Value.
2.14.11
Fixed Volume Value
Sets the fixed value the volume can have. If Fixed Volume Limit is ON, volume is set with the value here.
2.14.12
Headphone Direct Volume
Enables to could set via headphone volume dialog the headphone volume level.
If it is changed to enable then V+/- keys will change HP volume and left/right option will change speaker
volume unless there is any open OSD. If it is disabled it will behave as normal.
volume unless there is any open OSD. If it is disabled it will behave as normal.
Volume control and HP volume control are displayed by volume slider menu.
2.14.13
OSD Disable
Disables either only INSTALL menu or all menus, both in analog and digital (IDTV) mode.
OSD Disable = Disable All Menus
: All menus (MAIN, SOUND, PICTURE, SETTINGS, and
INSTALLATION) are invisible.
OSD Disable = Disable Setup Menus
: Only SETUP menus are invisible.
Invisible Setup Menus are:
Main menu: Installation, Channel list
Settings menu: Language, parental, Sources, Other settings
2.14.14
Teletext
Enables (Teletext = On) or prohibits (Teletext = Off) the use of teletext (or MHEG if available)
2.14.15
Copy To USB
There are two steps and both are independent of each other.
Copy the updated welcome image to USB as “hotel_wel.png”
Copy NVRAM data (service list, preferences, etc.) to USB device. When Copy to USB is called, those files are
copied from TV to USB. Then they can be used for various purposes testing on another TV or testing/debugging
on observatory etc. Note that USB should be plugged before this operation.
copied from TV to USB. Then they can be used for various purposes testing on another TV or testing/debugging
on observatory etc. Note that USB should be plugged before this operation.
Click on the first or last page to see other LC-32SH130K (serv.man11) service manuals if exist.