LC-22DV240K - Sharp TV Parts Guide (repair manual). Page 12

Read Sharp LC-22DV240K Parts Guide online

12
LC-22DV240
LC-22DS240
Operation Manual (Continued)
Connecting to a DVD Player 
via Component Sockets 
(YPbPr) or Scart Cable
Some DVD players are connected through 
COMPONENT SOCKETS (YPbPr). In this case, 
you must use the supplied Component video 
connection cable for enabling connection. First, 
plug single jack of the cable to the TV’s YPbPr 
socket (side). Afterwards, insert your component 
cable’s (not supplied) connectors into the 
socket
part of the Component video connection cable (see 
illustration below). Colours of the connected jacks 
should match. 
To enable audio connection, use the 
VGA/Component 
Audio cable. First, plug single jack of the cable 
to the TV. Afterwards, insert your DVD player’s 
audio cable’s connectors into the 
socket
part of the 
VGA/Component audio connection cable (see
illustration below
). Colours of the connected jacks 
should match. 
YPbPr
Side  view
DVD  Player
Connection  Cable
(supplied)
YPbPr  Video  Cable
(Not  supplied)
When the connection is made, switch to 
YPbPr source. See, Input selection section.
Note: To connect YPb Pr device, you should use supplied 
component (YPbPr) connection cable
You may also connect through the 
SCART input.  
SPDIF
SCART
VGA
Coax.OUT
1
Scart Cable
(not supplied)
External device
Note
• 
: These three methods of connection perform the 
same function but in different levels of quality. It is not 
necessary to connect by all three methods.
Multipartiton support is available. Maximum two
different partitions are supported. If the disk have
more than two partitions, crash may occur.  First
partition of the usb disk is used for PVR ready
features. It also must be formatted as primary
partition to be used for PVR ready features
.
Some stream packets may not be recorded  because
of signal problems, so sometimes video may freezes
during playback. 
Record, Play, Pause, Display (for PlayListDialog)
keys could not be used when teletext is ON. If a
recording starts from timer when teletext is ON,
teletext is automatically turned off. Also teletext
usage is disabled when there is ongoing recording 
or playback.
• Radio record is not supported
.
• The TV can record programmes up to ten hours
.
Connecting to a DVD Player via HDMI
Please refer to your DVD player’s instruction book 
for additional information. Power off both the TV and 
the device before making any connections.
Note
: Not all cables shown in the illustration are 
supplied.
If your DVD player has an 
HDMI socket, you can 
connect via HDMI for better video and audio quality.
SPDIF
SCART
VGA
Coax.OUT
1
External device
(not supplied)
HDMI Cable
When you connect to DVD player as illustrated above, 
switch to the connected HDMI source. See, Input 
Selection
 section for more information on changing 
sources.
A01_MB62_[GB]_(01-TV)_1910UK_IDTV_TC_PVR_BRONZE19_22942LED_ROCKER_ZIGGO_10075860_50201267.indd 12
16.01.2012 14:13:54
Page of 82
Display

Click on the first or last page to see other LC-22DV240K service manuals if exist.