XV-Z200E (serv.man32). (2) Connections setup - Sharp Projector User Guide / Operation Manual. Page 9

To INPUT 2 terminal

Notebook computer

To RGB output terminal

RGB cable
(commercially available)

DVI to 15-pin D-sub adaptor

(sold separately)

Optional
accessory

DVI to 15-pin D-sub adaptor
Type: AN-A1DV (20 cm)

• Secure the connectors by tightening the

thumbscrews.

Note

• Refer to “Computer Compatibility Chart” on

page  66 for a list of computer signals
compatible with the projector. Use with
computer signals other than those listed may
cause some of the functions not to work.

• When connecting the projector to a computer

in this way, select “RGB” for “Signal Type” on
the OSD menu or press 

 on the remote

control. (See page 52.)

• A Macintosh adaptor may be required for use

with some Macintosh computers. Contact your
nearest Sharp Authorised Projector Dealer or
Service Centre.

• Depending on the computer you are using, an

image may not be projected unless the signal
output setting of the computer is switched to
the external output. Refer to the computer op-
eration manual for switching the computer sig-
nal output settings.

■ Connect the thumbscrew cable making sure that it fits cor-

rectly into the terminal. Then, firmly secure the connec-
tors by tightening the screws on both sides of the plug.

■ Do not remove the ferrite core attached to the RGB cable.

XV_Z200E_E_p13_24.p65

03.10.30, 13:13PM

21