Read Sharp XR-20X Handy Guide online
Lamp Replacement Procedure
Version 1.1
Issue 04/2006
Issue 04/2006
11
SHARP ELECTRONICS (UK) LTD
PROJECTOR TECHNICAL SUPPORT
TECHNICAL SERVICES GROUP
Removing and Installing the Lamp Unit
Note
•
Ensure the lamp unit is removed using the handle. Ensure the glass surface of the lamp
unit or the insides of the projector are not touched.
unit or the insides of the projector are not touched.
•
To avoid injury to yourself and damage to the lamp, ensure to carefully follow the steps
below.
below.
•
Do not loosen other screws except for the
lamp unit cover and lamp unit. (Only the silver
screws are loosened).
lamp unit cover and lamp unit. (Only the silver
screws are loosened).
1.
Press “STANDBY” on the projector to
turn off the power.
turn off the power.
•
Wait until the cooling fan stops.
Warning!
•
Do not remove the lamp unit from the
projector right after use. The lamp will be very
hot and may cause burn or injury.
projector right after use. The lamp will be very
hot and may cause burn or injury.
2.
Disconnect the power cord.
•
Unplug the power cord from the AC socket.
•
Leave the lamp until it has fully cooled down
(about 1 hour).
(about 1 hour).
3.
Remove the lamp unit cover.
•
Turn the projector over. Loosen the user service
screw (1) that secures the lamp unit cover. Pressing
the tab, remove the lamp unit cover (2).
screw (1) that secures the lamp unit cover. Pressing
the tab, remove the lamp unit cover (2).
4.
Remove the lamp unit.
•
Loosen the securing screws from the lamp unit. Hold the lamp
unit by the handle and pull it in the direction of the arrow.
unit by the handle and pull it in the direction of the arrow.
Click on the first or last page to see other XR-20X service manuals if exist.