XG-V10XE (serv.man26). - Setup Connections - Sharp Projector User Guide / Operation Manual. Page 6

Press the MAIN POWER switch on the side of the
projector. The POWER indicator lights up red and the
projector enters standby mode.

• When the main power is not on, the remote control cannot

be used to operate the projector.

TEMP

LAMP2

LAMP1 POWER

2

1

Press POWER ON.

• The flashing green LAMP REPLACEMENT indicator

shows that the lamp is warming up. Wait until the
indicator stops flashing before operating the projector.

• If the power is turned off and then immediately turned

on again, it may take a short while before the lamp
turns on.

• After the projector is unpacked and turned on for the first

time, a slight odour may be emitted from the exhaust
vent. This odour will soon disappear with use.

When the power is on, the LAMP REPLACEMENT
indicator lights, indicating the status of the lamp.
Green: Lamp is ready.
Flashing green: Warming up.
Red: Change the lamp.

• When setting the lamp mode to “Lamp 1 only” or “Lamp

2 only”, only the LAMP REPLACEMENT indicator
corresponding to the lamp set is lit.

TEMP

LAMP2

LAMP1 POWER

2

1

POWER

buttons

Press POWER OFF.

Press  POWER OFF again while the message is
displayed.

• If you accidentally pressed POWER OFF and do not want

to turn off the power, wait until the power off screen
disappears.

• When POWER OFF is pressed twice, the POWER indicator

will light up red and the cooling fan will run for about 90
seconds. The projector will then enter standby mode.

• Wait until the cooling fan stops before disconnecting the

power cord.

• The power can be turned on again by pressing POWER

ON. When the power is turned on, the POWER indicator
and the LAMP REPLACEMENT indicators light green.

• The POWER indicator flashes if the front filter is not securely

installed.

WARNING:
The cooling fan in this projector continues to run for
about 90 seconds after the projector is turned off.
During normal operation, when turning the power off
always use the POWER OFF button on the projector or
the remote control. Ensure the cooling fan has stopped
before disconnecting the power cord.
DURING NORMAL OPERATION, NEVER TURN THE
PROJECTOR OFF BY DISCONNECTING THE POWER
CORD. FAILURE TO OBSERVE THIS WILL RESULT IN
PREMATURE LAMP FAILURE.