XG-P20XE (serv.man19). Section 3 Operation buttons - Sharp Projector User Guide / Operation Manual. Page 9

• Make sure to turn off GyroRemote aboard aircraft or other places where using radio signals is prohibited.

Press TEACH and RF CH

ⴐ located inside the upper

cover at the same time for over 2 seconds, the LED
will flash 3 times and the GyroRemote will turn off.

If the LED doesn’t light up after pressing any of the
buttons (except POWER), the GyroRemote power
is turned off.

• Press TEACH and RF CH

ⴐ at the same time or POWER located

inside the upper cover of the GyroRemote to turn the power on.

• When the power is turned off, the GyroRemote is protected from

malfunctioning or battery depletion if control buttons are
inadvertently pressed.

When the GyroRemote cannot be used due to the range or positioning of the projector (rear projection, etc.),
connect a ø3.5 mm stereo minijack cable (sold separately) from the wired remote control input on the bottom of
the remote control to the WIRED REMOTE control input terminal on the rear of the projector.

ø3.5 mm stereo minijack cable
(sold separately)

ø2.5–ø3.5 mm wired
remote control cable
(supplied)

TEACH

RF CH+

POWER

LED

Slide the IR/Gyro switch to the Gyro position.

• GyroRemote will lose its source of power if it detaches from the ø2.5–ø3.5 mm wired remote control cable.

You can use the IR remote control by connecting a ø3.5 mm stereo minijack cable (sold separately) from the wired
remote control input on the bottom of the remote control to the WIRED REMOTE control input terminal, a SHARP
product.
Slide the IR/Gyro switch to the IR position.

IR/Gyro switch