XG-P20XE (serv.man19). Section 3 Operation buttons - Sharp Projector User Guide / Operation Manual. Page 8

• Each GyroRemote has its own ID code, which must be recognized by the projector that is going to be used.
• The projector only recognizes the signal of the GyroRemote whose ID code has been input. Signals from other

projectors or GyroRemotes that may be operating in the same area are not allowed to interrupt each other.

LEARN

TEACH

Press LEARN on the projector.

While “Do you want to LEARN?” is displaying, press
ENTER. You are now in LEARN mode.

• Entering LEARN mode erases all previously registered

GyroRemotes data. You must re-enter each GyroRemote ID code
in order for the projector to recognise them again.

Press TEACH located on the front, inside the upper
cover on the remote within 5 minutes. “Register” will
appear on the display and you can now start using
the GyroRemote with the projector.

To exit from the LEARN mode, press LEARN.

• Be aware that you can operate multiple projectors with one

GyroRemote, even if you are in another room, as long as you
stay within a 98

⬘ 5⬙ (30 m) range of the projector.

• LEARN mode will exit if the LEARN is pressed or 5 minutes has

elapsed.

Set projector to LEARN mode.

Press  TEACH  on the GyroRemote. You can now
operate multiple projectors with one GyroRemote.

Perform steps 1 and 2 for each projector you plan to
use.

To exit from LEARN mode, press LEARN.

• For setting multiple units in LEARN mode at one time, perform step

1 above for all projectors.

One projector can recognize up to 8 GyroRemote ID
codes.

Set projector to LEARN mode.

Press TEACH on all GyroRemotes being used. Once
the eighth GyroRemote is registered to operate one
projector, the LEARN mode automatically finishes.
You can now operate one projector using multiple
GyroRemotes.

To exit from the LEARN mode, press LEARN.

• Contact your nearest Sharp Authorised LCD Projector Dealer or

Service Centre if you need to use an additional GyroRemote unit.