Read Sharp PG-M10SE (serv.man18) User Guide / Operation Manual online
33
Menu Operation
Auto Source Settings
With this function, the unit is automatically detecting the
input signal.
input signal.
1
With the FLIP COVER of the remote control
open, press the MENU button to display the
Advanced menu, then use the cursor
open, press the MENU button to display the
Advanced menu, then use the cursor
씱 / 씰
keys to select “SETUP”.
2
Use the cursor
/
keys to select “AUTO
SOURCE”, then use the cursor
씱 / 씰 keys
to set “ON” or “OFF”.
ON:
All input signals are detected.
OFF:
Remote control VIDEO button:
Video and S-video are detected.
Remote control COMPUTER button:
RGB and YP
Video and S-video are detected.
Remote control COMPUTER button:
RGB and YP
B
P
R
signals are detected.
Main unit INPUT SELECT button:
All input signals are detected individually.
All input signals are detected individually.
Selecting a Projection Format
If the projection format is not correctly set in accordance
with the installation conditions, images may be projected
reversed, vertically, or horizontally.
with the installation conditions, images may be projected
reversed, vertically, or horizontally.
1
With the FLIP COVER of the remote control
open, press the MENU button to display the
Advanced menu, then use the cursor
open, press the MENU button to display the
Advanced menu, then use the cursor
씱 / 씰
keys to select “SETUP”.
2
When “SETUP” menu is displayed, use the
cursor
cursor
/
keys to select “PROJECTION”,
then press the ENTER button.
3
Use the cursor
/
keys to select a
projection format in accordance with the set
conditions.
conditions.
The setting items will change as shown below each
time a key is pressed.
NORMAL
time a key is pressed.
NORMAL
⇔
VERTICALLY+HORIZONTALLY
REVERSED VERTICALLY
⇔ REVERSED HORIZONTALLY
• The unit cannot be installed to the ceiling.
• When installing the unit upside down, do not block the
• When installing the unit upside down, do not block the
exhaust vents at the top and on the sides. Be sure to
always leave a space of minimally 5 cm (1
always leave a space of minimally 5 cm (1
15
/
16
") between
the unit and the stand it is installed on.
• Be sure to always leave a space of minimally 20 cm (7
7
/
8
")
between the unit and surrounding obstructions.
• Do not use an installation stand made of material that is not
heat-resistant.
• During an earthquake or when a child climbs on top of or
hangs from the stand, the unit may fall. Use a wall or a post
as a measure to prevent the unit from falling.
as a measure to prevent the unit from falling.
Using the Power Saving Function
When there is no signal input for a period of 5 min. or more,
the power is automatically turned off and standby status is
activated.
the power is automatically turned off and standby status is
activated.
1
With the FLIP COVER of the remote control
open, press the MENU button to display the
Advanced menu, then use the cursor
open, press the MENU button to display the
Advanced menu, then use the cursor
씱 / 씰
buttons to select “SETUP”.
2
When “SETUP” menu is displayed, use the
cursor
cursor
/
keys to select “AUTO POWER
OFF”.
3
Use the cursor
씱 / 씰 keys to set Power
Saving to “ON” or “OFF”.
To close the menu
Press the R-CLICK/UNDO button.
Press the R-CLICK/UNDO button.
Initial Settings
⇔
⇔
Click on the first or last page to see other PG-M10SE (serv.man18) service manuals if exist.