PG-B10S (serv.man35). (part 4) Corrections, screen setup, appendix - Sharp Projector User Guide / Operation Manual. Page 2

•

Secure the connectors by tightening the
thumbscrews.

Note

•

If the projector does not automatically detect
a RGB signal, the projected image will appear
distorted. To correct, change the menu setting
from “Auto” to “RGB”. The menu setting can
be found in the “Picture” menu. See page 

.

•

 “Computer Compatibility Chart”

for a list of computer signals compatible with
the projector. Use with computer signals other
than those listed may cause some of the func-
tions to not work.

•

A Macintosh adaptor may be required for use with
some Macintosh computers. Contact your nearest
Sharp Authorized Projector Dealer or Service Center.

•

Depending on the computer you are using,
an image may not be projected unless the sig-
nal output setting of the computer is switched
to the external output. Refer to the computer
operation manual for switching the computer
signal output settings.

•

When using the ø3.5 mm mono audio cable,
the volume level will be half of when using
the ø3.5 mm stereo audio cable.

Supplied
accessory

RGB cable

Computer

2

ø3.5 mm  stereo or mono audio
cable (commercially available or
available as Sharp service part
QCNWGA038WJPZ)

1

RGB cable

To RGB output terminal

To audio output terminal

■ This projector is compatible with VESA-standard DDC 1/DDC 2B. The projector and a VESA DDC

compatible computer will communicate their setting requirements, allowing for quick and easy setup.

■ Before using the “Plug and Play” function, be sure to turn on the projector first and the connected

computer last.

Note

•

The DDC “Plug and Play” function of this projector operates only when used in conjunction with a VESA
DDC compatible computer.