MX-SP10. MX-RP13 MX-SP10 MX-CS10 Complete Service manual - Sharp Copying Equipment Service Manual (repair manual). Page 8

MX-RP13/SP10/CS10  UNPACKING AND INSTALLATION  2 - 5

：'11/Mar/14

8)

Insert the drum cartridge and the DV cartridge into the copier.

Open the tray, the side door, and the front cabinet, insert the
drum cartridge and the DV cartridge, and then close the front
cabinet, the side door, and the tray.

Note: When closing, be sure to carry out the operation in the

order of (1), (2), (3), (4), and (5) as illustrated below.

9)

Remove the paper tray lock for packing.

Remove the tray lock by rotating the lock counter-clockwise
and store the lock in the specified position as illustrated below.

10) Set the paper tray length guide.

Squeeze the lever of the paper tray length guide to slide the
guide to the position for the paper size to be used.

11) Load paper into the paper tray.

When loading paper, do not exceed the maximum height line.

12) Insert the power plug into the outlet and turn the main switch to

the “ON” position. Then, perform the following procedure.

13) Perform SIM setting.

Execute simulation [3] of [26] and enter [1].

14) Check the center displacement.

Place an original on the document glass and make a copy
using the tray in the copier.

Then, make a copy using the tray in the installed optional
paper feed unit.

If the center of the copy output from the document glass or the
document feeder is displaced from tray 2, perform the center-
ing adjustment referring to the service manual of the MX-B200/
B201D.