Read Sharp MX-SP10 Service Manual online
MX-RP13/SP10/CS10 UNPACKING AND INSTALLATION 2 - 4
2)
Place the copier on it's right side.
Close the front cover, side cover, and bypass tray, and then
place the copier on it's right side cover as shown in the illustra-
tion.
place the copier on it's right side cover as shown in the illustra-
tion.
3)
Remove the OP gear cover and rubber feet from the bottom of
the copier.
the copier.
Remove the screw and remove the OP gear cover.
Then, take off and remove the rubber feet.
4)
Install the second cassette unit to the copier.
If the second cassette unit is aligned to the copier, it can be
positioned automatically.
positioned automatically.
Secure the copier to prevent it from falling over and secure the
second cassette unit with four screws (M4 x 16).
second cassette unit with four screws (M4 x 16).
5)
Remove the rear cover and connect the connector.
Remove the screw and remove the rear cover of the additional
cassette.
cassette.
Then, connect the connector of the second cassette unit to that
of the copier.
of the copier.
6)
Attach the rear cover.
Attach the rear cover to its original position and secure it with
the screw (M4 x 12).
the screw (M4 x 12).
7)
Return the copier to the normal orientation.
Carefully lower the machine when returning the copier to it's
original orientation.
original orientation.
Rubber foot
OP gear cover
Rubber foot
Click on the first or last page to see other MX-SP10 service manuals if exist.