Read Sharp MX-PEX1 (serv.man4) Service Manual online
MX-PEX1 Unpacking, installtion 1 – 2
B. Install of the I/F unit
1)
Remove the ozone filter cover. Remove the screws, and
remove the right rear cabinet cover.
remove the right rear cabinet cover.
2)
Remove the screws, and pull out the MFP cnt PWB unit.
3)
Remove the three screws of the MFP cnt PWB. Install the I/F
unit (package part No. 1) with the three screws that was
detached from MFP cnt PWB.
* When installing the I/F unit, use an extreme care to make
unit (package part No. 1) with the three screws that was
detached from MFP cnt PWB.
* When installing the I/F unit, use an extreme care to make
the sheet metal not come in contact with the MFP cnt PWB.
4)
Restore the MFP cnt PWB unit to the main unit, and fix with the
screws.
screws.
5)
Cut out the cut-out portion of the right rear cabinet cover for
cable along the perforated line. Attach the right rear cabinet
cover, and fix with the screw. Attach the ozone filter cover.
cable along the perforated line. Attach the right rear cabinet
cover, and fix with the screw. Attach the ozone filter cover.
C. Installation of the printer controller
1)
Remove the four screws from the rear cabinet. Attach two step
screws (package part No. 1) to the two positions in four posi-
tions where the fixing screws have been removed.
screws (package part No. 1) to the two positions in four posi-
tions where the fixing screws have been removed.
2)
Engage the printer controller unit with the step screws, and
slide it to the right door side.
slide it to the right door side.
3
2
1
1
2
3
4
3
2
1
D01000221202G
1
1
1
1
2
1
2
Click on the first or last page to see other MX-PEX1 (serv.man4) service manuals if exist.