MX-M950, MX-MM1100 (serv.man15). Details of Each Section - C DSPF Section - Sharp Copying Equipment Service Manual (repair manual). Page 11

MX-M1100  DSPF SECTION  C – 11

4)

Remove the screw (a), and disconnect the connector (b).
Remove the mounting plate (c).
* When connecting, arrange the harness of the connector (b)

under the sensor. 

5)

Remove the screw (a), and remove the DSPF paper pass sen-
sor 2 (b).
* When installing the sensor, check to confirm that the sensor

boss (c) is securely engaged and fix it with the screw.

6)

Disconnect the connector (a), and remove the DSPF upper
door open/close sensor (b).

7)

Disconnect the connector (a). Remove the screw (b) and the
plate (c). Remove the DSPF double feed sensor (transmitting)
(d).
* When installing the double feed sensor (transmitting), check

to confirm that "S" mark (e) is engraved on the top of the
sensor.

* Install so that the white dot (a) on the side of the sensor

faces toward the marking (b) and so that the white dot (a)
can be seen from the slit.

8)

Remove the tape (a), and disconnect the connector (b). 
Remove the screw (c) and the holder (d). Remove the DSPF
double feed sensor (receiving) (e).
* When installing the double feed sensor (receiving), 

check to confirm that "R" mark (f) is engraved on the top of
the sensor.

a

c

b

a

b

c

a

b

b

c

a

d

e

b

a

a

b

e

c

d

f