MX-M850 (serv.man36). Section 6 Adjustments - Sharp Copying Equipment Service Manual (repair manual). Page 80

MX-M1100  ADJUSTMENTS  6 – 80

6)

Press [EXECUTE] key.
The automatic adjustment is executed.

7)

Press [OK] key.
The adjustment result becomes valid.

 

1)

Enter the Sim. 50-28 mode.

2)

Press [SETUP/PRINT ADJ] button to select [SETUP/PRINT
ADJ] mode.

3)

Press [ALL] button to select [ALL] mode.

Note:
The adjustment can be performed individually in the [LEAD]
mode or in the [OFFSET] mode.
LEAD: Print image lead edge image position adjustment
OFFSET: Print image off-center adjustment
When [ALL] is selected, the above two adjustments are per-
formed simultaneously.

4)

Select the paper feed tray to be adjusted.

5)

Press [EXECUTE] key.
The adjustment pattern is printed.

6)

Set the adjustment pattern on the document table. (No need to
take care of the setting direction.)
Note: Set the adjustment pattern so that it fits precisely with
the document guide. 

7)

Press [EXECUTE] key.
The automatic adjustment is executed.

8)

Press [OK] button.
The adjustment result becomes valid.
Perform the procedures 4 thru 7 for each paper feed tray. 

SIMULATION NO.50-28

TEST

AUTO IMAGE POSITION ADJUSTMENT㧦SERVICE

CLOSE

BK-MAG

㧦㧖㧖㧔㧖㧖㧕

RETRY

RESCAN

REPRINT

OK

DATA

SIMULATION NO.50-28

TEST

AUTO IMAGE POSITION ADJUSTMENT : SERVICE

OC ADJ

BK-MAG ADJ

SPF ADJ

SETUP/PRINT ADJ

RESULT

DATA

1/1

CLOSE

SIMULATION NO.50-28

TEST

AUTO IMAGE POSITION ADJUSTMENT㧦SERVICE

LEAD

OFFSET

ALL

1/1

CLOSE

0

SIMULATION NO.50̆28

TEST

AUTO IMAGE POSITION ADJUSTMENT㧦SERVICE

EXECUTE

1/1

MFT

CS1

CS2

CS3

CLOSE

CS4

ADU

LCC1

LCC2

LCC3

0

SIMULATION NO.50̆28

TEST

AUTO IMAGE POSITION ADJUSTMENT㧦SERVICE

CLOSE

PRINT LEAD          㧦MFT㧖㧖㧔㧖㧖㧕CS1/CS2㧦㧖㧖㧔㧖㧖㧕 ADU㧦㧖㧖㧔㧖㧖㧕

   㧦

CS3/ CS4㧖㧖㧔㧖㧖㧕LCC㧦㧖㧖㧔㧖㧖㧕

PRINTER OFFSET       㧦MFT㧖㧖㧔㧖㧖㧕 CS1㧦㧖㧖㧔㧖㧖㧕CS2㧦㧖㧖㧔㧖㧖㧕 ADU㧦㧖㧖㧔㧖㧖㧕

 㧦

CS3㧖㧖㧔㧖㧖㧕 CS4㧦㧖㧖㧔㧖㧖㧕LCC㧦㧖㧖㧔㧖㧖㧕

RETRY

RESCAN

REPRINT

OK

DATA