Read Sharp MX-M850 (serv.man36) Service Manual online
MX-M1100 ADJUSTMENTS 6 – 3
3. Datails of adjustment
ADJ 1
High voltage values adjustment
(Note)
To check and adjust the output voltage, use the unit which can
measure an effective value of 1000M
To check and adjust the output voltage, use the unit which can
measure an effective value of 1000M
Ω or more internal imped-
ance. In addition, use a high voltage probe as well.
(FLUKE87FLUKE80K-40 is recommended.)
(FLUKE87FLUKE80K-40 is recommended.)
1-A
Main charger grid voltage adjustment
This adjustment is needed in the following situations:
* When the high voltage MAIN PWB is replaced.
* U2 trouble has occurred.
* The PCU PWB has been replaced.
* The EEPROM of the PCU PWB has been replaced.
1)
* When the high voltage MAIN PWB is replaced.
* U2 trouble has occurred.
* The PCU PWB has been replaced.
* The EEPROM of the PCU PWB has been replaced.
1)
Enter the Sim. 8-2 mode.
2)
Select the output mode to be adjusted with the scroll button.
3)
Enter the adjustment value with 10-key, and press [OK] button.
The adjustment value is set.
Normally when the default value is set, the specified voltage is
outputted.
The adjustment value is set.
Normally when the default value is set, the specified voltage is
outputted.
When [EXECUTE] button is pressed, the adjustment value is saved
and the main charger voltage is outputted.
When the output voltage must be checked or adjusted, follow the
procedure below:
1)
and the main charger voltage is outputted.
When the output voltage must be checked or adjusted, follow the
procedure below:
1)
Remove the upper rear cover of the machine
2)
Attach the digital multi-meter between the connector CN2 pin
(3) on the high voltage main PWB and GND.
(3) on the high voltage main PWB and GND.
3)
Enter the adjustment value with 10-key, and press [EXECUTE]
key.
The main charger voltage is outputted for 10sec.
Note:
Perform this procedure timely as extended charge output will
stress the photoconductor.
key.
The main charger voltage is outputted for 10sec.
Note:
Perform this procedure timely as extended charge output will
stress the photoconductor.
A㧦580
㧧
COPY
B㧦580
㧧
PRINTER
C㧦580
㧧
FAX
0
A:
SIMULATION NO.08㧙02
MHV/GRID SETTING AND OUTPUT
580
㨇
200 㨪1000 㨉
OK
TEST
EXECUTE
CLOSE
Item/Display
Content
Setting
range
Default
Monitor connector
Actual output voltage
85-sheet
model
95/110-
sheet model
Connector
Pin No.
85-sheet
model
95/110-sheet
model
A
COPY
Main charger grid voltage adjustment value
(Copy mode)
(Copy mode)
200-1000
560
580
CN2
3
-590
± 1 V
-610
± 1 V
B
PRINTER
Main charger grid voltage adjustment value
(Priner mode)
(Priner mode)
200-1000
560
580
CN2
3
-590
± 1 V
-610
± 1 V
C
FAX
Main charger grid voltage adjustment value
(FAX mode)
(FAX mode)
200-1000
560
580
CN2
3
-590
± 1 V
-610
± 1 V
CN2
Click on the first or last page to see other MX-M850 (serv.man36) service manuals if exist.