MX-M364N, MX-565N (serv.man5). Installation Manual (Revised January2016). - Sharp Copying Equipment Service Manual (repair manual). Page 13

MX-M565N  MX-M365N/M465N/M565Nseries MX-M364N/M464N/M564Nseries AR-M460N/M560N series  1 – 6

3)

Insert the cartridge securely until it locks.

1)

Pull out the paper tray.

Gently pull the tray out until it stops.

If paper remains in the tray, remove it.

2)

Adjust the guide plates A and B by squeezing their lock levels
and sliding them to match the vertical and horizontal dimen-
sions of the proper to be loaded.
The guide plates A and B are slidable, slide each guide plate
while squeezing lock lever.

Be sure to check the following items related to image quality. For
details of the adjustment and checking procedures, refer to the “[5]
ADJUSTMENT” on the Service Manual.

Check that the following items are within specification. If not, carry
out the adjustment.

NOTE: When installing the copier, be sure to carry out the copy

gray balance and the printer gray balance.

1)

Enter the SIM 46-74 mode. 

2)

Press [EXECUTE] button. 

The high density process control is performed, and the copy
gray patch image (adjustment pattern) is printed out. 
(A4/11" x 8.5" or A3/11" x 17" paper is automatically selected.)

3)

Set the gray patch image (adjustment pattern) paper printed in
procedure 2) on the document table. 

Set the gray patch image (adjustment pattern) printed in the
procedure 2) on the document table. 

Place the gray patch image so that the fine lines are on the left
side. 

At that time, place 5 sheets of white paper on the printed gray
patch image (adjustment pattern).

A

B