MX-M364N, MX-565N (serv.man5). Installation Manual (Revised January2016). - Sharp Copying Equipment Service Manual (repair manual). Page 8

MX-M565N  MX-M365N/M465N/M565Nseries MX-M364N/M464N/M564Nseries AR-M460N/M560N series  1 – 1

MX-M565N

Service Manual

 

Before installing the machine, check that the following installing
(use) conditions are satisfied.

If the installing (use) conditions are not satisfied, the machine may
not achieve full performances, resulting in troubles. It may also
cause safety problems. Therefore, be sure to provide the installing
(use) conditions before setting up the machine.

For installation of a large size machine, be sure to check that the
door size is wide enough before bringing in.

The following space must be provided around the machine in order
to assure machine performances and proper operations.

If any option is installed, provide the additional space for installing
it.

Adequate space must be provide behind the machine for proper
ventilation heat and dust. If not, the machine cannot exhibit func-
tions against heat and dust, causing some troubles.

If the power specifications are not satisfied, the machine cannot
exhibit full performances and may cause safety trouble.

Strictly observe the following specifications.

Check that the following power capacity is satisfied. If not, addition-
ally provide a power source.

Japan: 20A or more

100V: 15A or more

200V: 10A or more

NOTE: Check the shape of the power plug of the machine, and

insert it into a power outlet of the acceptable shape.

Measure the voltage during copying to check that the voltage is in
the range of the specified voltage +/-10%.

If the voltage is outside the specified range, call a qualified electri-
cian and have the proper voltage/amps/hertz supplied to the copier.

(An electrical work is required.)

Call a qualified electrician and have the proper voltage/amps/hertz
supplied to the copier. In this case, the capacity must be great
enough for the max. power consumption of the machine.

The frequency must be within the range of the specified frequency
+/-2%. If power waveform is deformed, a trouble may occur.

Be sure to properly ground the machine.

Grounding (earth connection) must be performed before inserting
the power plug into the power outlet.

When disconnecting the earth connection, be sure to disconnect
the power plug from the power outlet in advance.

Check the shape of the power plug of the machine, and insert it into
a power outlet of the acceptable shape.

This machine is considerably heavy and becomes heavier with an
option installed.

The floor must be strong enough for assuring safety.

If the unit is not horizontally installed, the toner density control is not
performed normally, degrading the copy quality.

If not, color shift or image distortion may occur.

This machine is designed to perform properly under the specified
temperature and humidity. If the temperature and humidity exceeds
the specified range, the machine may not operate properly and or
cause equipment failure.

Especially when the humidity is too high, paper absorbs humidity to
cause a paper jam or dirty copy.

Do not install the machine near a heater, a cooler, or a humidifier.

Dew may be formed inside the machine to cause a trouble. Use
enough care for ventilation.

-  Working environment

Temperature: 10 to 35 degrees C

Humidity: 20 to 85% RH

Atmospheric pressure: 590 to 1013hPa (altitude: 0 to 2000 m)

1

Bringing space

2

Installing space

3

Power source (Capacity, fluctuation, safety)

4

Floor strength

5

Direct rays of the sun, dust, temperature, humidity, gases, 
chemicals

11-13/16" 
(30cm)

11-13/16" 
(30cm)

17-23/32" 
(45cm)

85%

Humidity㧔RH㧕

60%

20%

: ‘16/Jan