MX-M364N, MX-565N (serv.man4). Service Manual (Revised January 2016). - Sharp Copying Equipment Service Manual (repair manual). Page 96

MX-M565N  ADJUSTMENTS AND SETTINGS  4 – 66

6)

Open the DSPF paper feed guide to the width for the A5R size.

7)

Press [EXECUTE] key.

The A5R width detection level is recognized.

8)

Open the DSPF paper feed guide to the minimum width posi-
tion.

9)

Press [EXECUTE] key.

The minimum width detection level is recognized.

* When each of the above operations has been completed,

the "COMPLETE" message appears; when any of the oper-
ations has failed, the "ERROR" message appears.

 

This adjustment is needed in the following situations:

* When the original size sensor section has been disassembled.

* When the original size sensor section has been replaced.

* When U2 trouble has occurred.

* When the scanner control PWB is replaced.

* When the EEPROM on the scanner control PWB is replaced.

 

1)

Enter the SIM 41-1 mode.

Loosen the original cover switch actuator adjustment screw
and slide the actuator position so that the display OCSW is
returned to the normal display when the height of the arm unit
top from the table glass is 32   0.5mm by slowly tilting the doc-
ument detection arm unit in the arrow direction and adjust. 
(If the ON timing of the original cover switch is shifted, the doc-
ument detection function may malfunction.)

 

1)

Enter the SIM 41-2 mode.

2)

Execute the sensor adjustment without document.

With the document cover open, without placing a document on
the table glass, press [EXECUTE] key.

3)

Place A3 (11" x 17") paper on the document table and press
[EXECUTE] key.

If the adjustment is completed normally, "DOCUMENT PHOTO
SENSOR LEVEL IS ADJUSTED" is displayed.

 

This adjustment is needed in the following situations:

* The operation panel has been replaced.

* U2 trouble has occurred.

* The scanner control PWB has been replaced.

* The EEPROM on the scanner control PWB has been replaced.

1)

Enter the SIM 65-1 mode.

2)

Precisely press the cross mark points (4 positions).

When the cross mark is pressed precisely, a buzzer sounds
and the display is reversed. When all the four points are
pressed and the touch panel adjustment is completed, the dis-
play returns to the simulation sub number entry screen. In
case of an error, the display returns to the entry screen again.

Check to confirm that there is no shift between the display
frame and the detection position when the touch panel is
pressed.

* When pressing the touch panel, never use a sharp tip (such

as a needle or a pin).

 

　　　S I MU L A TI O N　 　NO . 4 1- 0 1

  

 0

T E S T

CL O SE

OC S W

P D  S E NS O R  C H EC K

PD 1

P D 2

P D3

PD 4

PD 5

P D 6

P D7

1/ 1

10 K E Y

1 0K E Y

1 0K E Y

10 K E Y

1 0K E Y

1 0K E Y

10 K E Y

1 0K E Y

1 0K E Y

10 K E Y

1 0K E Y

1 0K E Y

10 K E Y

10 K E Y

1 0 KE Y

4

5

6

1

2

3

7

8

9

*

0

#

BA C K

S T AR T

EX I T

C LE A R

32  0.5mm

+

-